Примеры использования Flash mode на Английском языке и их переводы на Русский язык
{-}
- 
                                                                                        Official
                                                                                    
- 
                                                                                        Colloquial
                                                                                    
E-TTL II/E-TTL auto flash mode.
Flash mode/Red-eye reduction.
Set the camera's[Flash Mode] to Wireless.
Two flash modes, standard and speed.
Press 43 to select the flash mode, and press.
Flash mode Max. number of continuous firings.
MENU(Camera Settings)[Flash Mode] desired setting.
Flash Mode Sets the flash  settings.
Pegasus works via TAT mode, not using Flash mode like others.
Set the Flash mode to S-FL SLAVE.
The flash  automatically pops up when[Flash Mode] is set to Autoflash.
Available flash mode depends on the shooting mode. .
Synchronised flash  frequency or alternating flash mode in system operation.
The"Read Codes" button is used for reading unlock codes from the pnx490x based phone models in the flash mode.
When[Flash Mode] is set to[Flash Off] or Autoflash.
Resets the settings for each flash mode and flash  level settings.
Flash mode Max. number of continuous firings i-TTL auto flash. .
Filter& Lighting- keeps the filters and flash mode from the latest use of the Camera application.
The flash modes for groups A, B, and C can be set to[TTL] or MANUAL.
You can divide paired Wireless Radio Receivers in a maximum of five groups and set the flash mode or power level for each group.
Group settings flash mode and flash  compensation/flash level.
You can shoot with flash  units in various situations by setting the flash mode or flash's power level for each group.
The flash modes will cycle through ETTL, Manual(M) and Multi modes. .
On the flash  attached to the Wireless Radio Receiver,set the flash mode to TTL and the flash  coverage(zoom) to AUTO.
The flash modes will cycle through ETTL, Manual(M) and Multi modes. .
The"SWITCH TO FLASH  MENU" button puts the software into a flash mode and readies to flash  the handset with the particular flash  files.
Set the flash mode to[OFF] if you do not want the flashes  in the group to be used.
TAT mode  usage allows to avoid possible EEPROM checksum problems and damaged calibration settings on latest Swift-based phones,which can occur because of Flash mode.
You can also set the flash mode by pressing the(Flash Mode) on the control wheel.