Примеры использования Insertion loss на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Insertion loss:≤0.2dB.
Filters with small insertion loss;
Insertion loss:≤0.2dB.
Fiber Optic Coupler reduces insertion loss and deliver high performance.
Insertion Loss: LESS THAN 10db to 3GHz.
Low-noise signal amplifier compensates for insertion loss in coaxial.
Low insertion loss and low PDL.
Usual SAW transducer is a bidirectional radiator;this limits the minimum insertion loss at the level of 6 dB.
Insertion Loss: LESS THAN 10db to 3GHz.
Even pull off force is above 50N, The cable can fasten safety, will not damage to the fiber,also no extra insertion loss.
Excellent insertion loss value- 0,8 dB.
Even pull off force is above 50N, The cable can fasten safety, will not damage to the fiber,also no extra insertion loss.
Insertion loss of optical fiber connector:≤0.5dB.
At the same time, fiber optic adapters have the merits of low insertion loss, good interchangeability and reproducibility.
Low insertion loss and back reflection loss. .
PLC splitter has high-quality performance,such as low insertion loss, low PDL, high return loss, etc.
Insertion loss: 12 dB@ 1002 Hz balanced across inputs.
It can be easily applied in the construction of FTTx, construction of the optical network and CATV networks,maintaining low insertion loss.
Low insertion loss and back reflection loss. .
In the recent years,new SAW filter designs have appeared with the insertion loss at the level of 1…7 dB, due to making use of internal re-reflections, e.g.
Insertion Loss: less than 3dB per pair over the frequency range.
Operating frequency band is DC- 20 GHz,reference insertion loss is 2,2 dB at 20 GHz, attenuation band is 27 dB, input/ output return loss is better than 15 dB.
Insertion Loss: less than 3dB per pair over the frequency range.
This delay line including two interdigital transducers(IDT) was connected to meter of S- parameters E5071C,which allowed to measure the insertion loss and phase of output signal.
Insertion loss is relatively low, because the contacts are short.
The T.0X Subrack Passive Combiner provides excellent reliability and performance,high isolation between ports, low insertion loss, and great RF shielding for minimized egress/ingress interference.
In particular, small insertion loss, high selectivity and small squareness ratio.
This method uses splitter devices fabricated with silica optical wave-guide elements which result in low insertion loss, high uniformity, and low polarization-dependent loss(PDL).
Insertion Loss means the ratio of power that would be delivered to the load if the load were directly connected to the source divided by the power absorbed by the load when connected through the pad.
These LAN modules support the continued convergence of voice and data networking, computing, and storage traffic in the enterprise anddata center with excellent insertion loss, return loss, and crosstalk performance and reliability.