Примеры использования Mosfet на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
With the mosfet efficiency is greater.
Contact type contact maker normally open MOSFET.
Why not simply use a Mosfet or Darlington?
Contact type NO- normally open Relay/MOSFET.
Mosfet power amplifier for 2 meters band. Output power 1000 W.
Contact type contact maker normally open Relay/MOSFET.
We are also exploring the road of mosfet solid state relays.
Netzschalter Typ: OMNIFET:Fully Autoprotected Power MOSFET.
You can control the PWM Mosfet up to quite high frequencies, even hundreds of KHz.
Power Switch Type: OMNIFET:Fully Autoprotected Power MOSFET.
The transistor T1 is an alternative to the mosfet MFT1, If you mount one mounts the other.
MOSFET power device and PWM pulse width modulation technology are adopted to save energy and no noise in power frequency;
Then you can probably be able to dissipate just left mosfet, coricandolo.
When Vcc is at least a few volts, a MOSFET can be used for Q1 for lower dropout voltage.
The maximum current for each channel is over 10 Ampere, with the mosfet without heatsink.
In all cases(even with the Mosfet circuit) the mass of the PC and the external power supply must be connected to each other.
The version 1.8 includes many new models,including a thousand Mosfet in the file"Standard. mos.
Possible to directly drive MOSFET transistor to turn on/ off devices based on 12V DC(constant current, eg. LED lighting, RGB LED, Halogen).
Single-channel driver of power transistors with filed con- trol for single MOSFET or IGBT transistor control.
The EKV Mosfet model is a mathematical model of metal-oxide semiconductor field-effect transistors(MOSFET) which is intended for circuit simulation and analog circuit design.
This helps to maintain a straight PCB, andhelps lower mosfet temperatures by 7% and memory temperatures by 15%.
The process has three levels of aluminium interconnect andan effective channel length(the distance between the source and drain contacts of the MOSFET transistors) of 0.8 µm.
These are maximum current,If it exceeds 10 amps at Mosfet is well evaluated case-by-case basis and do many tests.
It was concluded that the power generation system comprising a permanent-magnet generator with a multilevel active rectifier and inverter based on the MOSFET modules is preferable to be used.
If the main power supply must supply the loads connected to the Mosfet then you must dimension taking account of these currents, up to about 16 Ampere.
Single-channel driver MOSFET- and IGBT-transistors 5DR1120 166 Single-channel driver of power transistors with field control 5DR1120 are intended to control a single MOSFET or IGBT transistor.
A reinforcement baseplate maintains a straight PCB, andhelps lower mosfet temperatures by 7% and memory by 15%.
Dennard scaling, also known as MOSFET scaling, is a scaling law based on a 1974 paper co-authored by Robert H. Dennard, after whom it is named.
Advantages of the Solid-State Technology Thermatool solid-state HF welders are based upon a current-fed design using proven MOSFET technology to deliver high power from low voltage.
There are also other mosfet similar to those recommended by us but you should be careful that must be very low with Gate-Source threshold voltage(less than 3 volts) otherwise I will close fine and warm with strong currents.