Примеры использования Rear bumper на Английском языке и их переводы на Русский язык
{-}
-
Colloquial
-
Official
New, more slender rear bumper design with.
The sensors are integrated in the front/rear bumper.
Front bumper assy+ Rear bumper assy+ Grille.
The ultrasonic sensors are integrated in the rear bumper.
Extend the rear bumper if the load box projects more than 400mm.
Remove the cap from the rear bumper» Fig. 164.
Set the rear bumper position if the load box projects more than 400mm.
There's a small recess inside the rear bumper molding.
Grip the cover on the rear bumper E» Fig. 133 at the handle D and position in.
The FlexFix carrier is integrated like a drawer in the rear bumper.
Installation of the front and rear bumper of the vehicle collision.
The variable loading floor can be partially pulled out over the rear bumper.
Proceed by inserting the bulbs into the rear bumper, as shown in the figure.
Unique front and rear bumper design including integrated exhaust finishers.
The ultrasonic sensors are integrated in the rear bumper» Fig. 97.
Offer up the cap to the rear bumper 2» Fig. 104 on page 117 aligning it with“check mark” in the lower bumper area.
They found a dent and paint transfer on the rear bumper of the reporter's car.
Remove the cover in the rear bumper 2» Fig. 100 on page 118 in the direction of the arrow using the tool for removing the wheel trims.
The ultrasonic sensors are integrated in the rear bumper» Fig. 98 on page 111.
Sound signals bounce off objects near the rear bumper and sensors, allowing the chipset Advanced calculate the distance between the object and the vehicle.
Turn the wheels to the left until you're lined up with the rear bumper of their car.
Option installed new rear bumper .6 optional ESP. ESP model P1359060006A0(0265244112), manufacturer of Bosch automotive Products(Suzhou) Co., optional front grille.
Fig. 133 Remove cap: on the rear bumper/ for receiving shaft.
Optional side trim panels;optional front bumper, rear bumper.
Makes sense, have to come from the rear bumper to the front of the driver.
Rear bumper protection by the composition, size 2230X470, bolted connections to, ground clearance is 450mm, cross-sectional diameter of 102mm; side protection for plug-box type, ground clearance is 425mm.
Press onto the bottom part of the cap in the rear bumper» Fig. 186- and remove it.
Owing to the recklessness of the driver of the Honda, he hit the rear bumper of the vehicle of the Cuban Mission driven by Mr. Ávila Ojeda.
Morris So C.S.U. found some fingertip impressions on the rear bumper of the car, caked in dirt.
Optional front bumper, headlights, front fog lights, front grille,rear lights, rear bumper, engine cover, fender, no optional front fog lights, rear wiper, brake light, tail election mounted wheels.