Примеры использования Resistance value на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Temperature Resistance value.
The resistance value of S1-103- less than 0,5 Ohm.
The higher the transformer rating, the higher the oil's pressure resistance value.
R rolling resistance value 0.01.
If the reading is accurate,the measured ground resistance value is reliable.
Maximum load resistance value, not more than 500.
To detect possible miswiring on the *9W model, it is highly recommended to measure the resistance value of the heater elements.
The insulation resistance value is not less than 0.5 megohm.
It is used for positioning a variety of wire and cable breakdown point or no breakdown butlow insulation resistance value defect point, and high-voltage….
Measure the resistance value to correct the influence of the lead.
Among them, NTC(Negative temperature coefficient of resistance) thermistor has a characteristic that the resistance value reduces when the temperature increases.
The resistance value of a typical material decreases as the ambient temperature and humidity increase.
For correct measurement one has to consider the tolerance in the base resistance value as well as the tolerance in the curve slope so-called B-value.
The closing resistance value and the input time of the contacts with 6 band resistance are tested;
Under normal temperature conditions, in the lower voltage range, the conductance current increases linearly with the increase of applied voltage, and the resistance value of the material remains the same.
The resistance value must be approximately equal to the characteristic impedance of the cable, In this case 50 ohm resistor.
The specific time depends on PTCR's heating capacity, resistance value, heating dissipation condition, overloaded resistance and operating voltage.
The resistance value displayed when the measuring tips are connected together is noted and subtracted from the subsequent measured values. .
When the circuit is in disorder,the PTC will generate heat suddenly, and the resistance value will go up to the high state, which can make the circuit relatively break up to protect the circuit.
The resistance value will change depending on the amount of incident radiation, because the incident infrared radiation will heat up the resistor structure.
Insert a resistor that does not cause the isolation resistance between the terminal being monitored andthe electrical chassis to drop below the minimum required isolation resistance value.
The insulation resistance value will decrease with the increase of temperature, so the general small and medium motor is required.
A resistor is inserted that does not cause the isolation resistance between the terminal being monitored andthe electrical chassis to drop below the minimum required isolation resistance value.
When measuring the resistance value of each heater, you can set the exact heater capacity and this will lead to more accurate energy data.
Thus, the higher the applied test voltage,the lower the resistance of the material, so that the resistance value of the material tested under different voltages may have a greater difference.
Its resistance value is far higher than that of C2, and the current goes through C1, C2, forming the return circuit and causing LC resonance and producing high pressure and lighting the tube.
Beyond a certain voltage, due to aggravate the ionization movement,the increase of conductance current is far faster than the test voltage increases, the resistance value of the material presented decreases rapidly.
The Switch Mode power supply circuit used in this example would normally use an inductor( L1)with a much lower resistance value, however the analysis results here do highlight that the basic SMPS model cannot take into account losses through L1- generally though, this would not be an issue in a practical circuit.
The dual-arm bridge subtly transfers the additional resistance such as contact resistance andlead resistance into the internal resistance of the bridge power supply, and is added to the bridge arm with relatively large resistance value.
In case the measurement is performed with a representative subsystem the final results for the system resistance value may be corrected if the internal connections between the subsystems have a significant influence on the resistance value.