Примеры использования Speaker cable на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
Audio Speaker Cable.
Speaker cables, coaxial.
Previous: Speaker Cable.
Speaker cable PVC, coaxial.
You need a commercially available speaker cable.
Next: Speaker Cable.
CONNECTIONS You need a commercially available speaker cable.
Make the speaker cables as short as possible.
Pin Wiring Harness Adapter Speaker Cable for TOYOTA.
The speaker cables are not connected properly.
Turn off the unit, reconnect the speaker cable, and then try YPAO measurement again.
A speaker cable is not included with this model.
HELUSOUND 400 PVC speaker cable, multicore, round.
A speaker cable is not included with this model.
Remove approximately 10 mm(0.4 in) of insulation from the end of each speaker cable and then twist bare wires of the cable together so that they will not cause a short circuits.
Speaker cable(2 m) x 2/ Grille x 2/ Non-skid pads(8 pcs.) x 1.
When connecting the speaker cable, leave the jumper cables in place.
Speaker cable(2 m)× 2/ Grille× 2 The speaker and the grille are packed separately.
Before connecting the speaker cable, you must remove the jumper cable. .
Speaker cables(long: 10 m, provided) Silver(cable): Connect this to the black negative(-) terminal.
When connecting the speaker cable, leave the jumper cables in place.
Speaker cable(2 m) x 2/ Grille x 2/ Non-skid pads(8 pcs.) x 1 The speaker and the grille are packed separately.
Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of the amplifier(or receiver) with the speaker cable.
Connect the speaker cables(provided) to the terminals.
A speaker cable is a pair of insulated cables running side by side in general.
Examples of non-standard wire would include doorbell wire,lamp cord, speaker cable, antenna wire, or any kind of stranded wire(telephone wire is always solid copper, neverstranded wire, except for the modular cords used to connect a telephone or telephone device to a wall jack).
Connecting speaker cables 1 Remove approximately 10 mm of insulation from the.
Connect the speaker cable to the terminals on the rear of the speaker. .
Connect the speaker cables properly and press the A switch again.
Press the speaker cables into the cable groove provided in the stand.