Примеры использования The output signal на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
The output signal depends on the supply voltage.
In the Name text box(2)enter the output signal name.
The output signal depends on the type of temperature transmitter.
Select the option for the output signal during calibration.
The output signal temporarily does not correspond to the measurement.
In measured value block 12 the output signal of the sender can be read.
Closed-loop transducers have an integrated current generator that supplies the output signal.
The output signal of the StepperDir specifies the direction of movement of the motor.
Activation function calculates the output signal, received after passing the accumulator.
The output signal is a proportional DC current which is linearly proportional to the input pressure.
This option sets Dolby Digital as the output signal for the DIGITAL OUT(OPTICAL) connector.
The output signal is a current of 1 UA for each degree Celsius starting from absolute zero.
This option sets MPEG AUDIO as the output signal for the DIGITAL OUT(OPTICAL) connector.
The output signal is conditioned in such a way"Gaussian" and"bipolar" for maximum measuring resolution.
These signals are processed in the electronic circuitry and used to control the output signal.
In some smartphones, the output signal through the headphones jack is too weak, so it needs to be amplified.
Due to the OLC(Optical Level Control),it will balance the output signal regardless of the number of channels.
This generator sends the output signal to a Slot, and not to the sound card as they usually similar generators.
This diverter catches the thread"STORE" and disconnect from the output signal of the Master.
You could input the output signal from one oscillator to another, achieving different kinds of ring modulation effects.
Check volume of source device;some devices will distort the output signal if the volume is set to maximum.
The output signal returns to the active state and the measured sample value is shown on the measure screen.
The output signal corresponds to the pump current which is necessary to set a constant oxygen content(lambda 1 corresponds to 450 mV) in a measuring cell.
Under-sized systems pose a safety risk since the output signal range is inadequate to meet code requirements.
Instead the output signal from our adapter is not a voltage variable like this, but different impulses amplitude, Depending on the size of individual grains.
Two sensors(FGM1 or FGM3)can be mixed with a simple D-type FlipFlop and the output signal is sent directly to a system PIN Theremino.
Please note that the output signal level of the detector is proportional to the input(very small, NB!) signal-to-noise ratio.