Примеры использования The stabilizer на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
The stabilizer is overloading.
Joysticks for the stabilizer and rudder.
The stabilizer of 4 points is the quaternion group.
Without the stabilizer, it will put tremendous stress on the core!
Люди также переводят
A The name and quantity of the stabilizer added.
A Yes, as the stabilizer itself is stable.
D When the cargo is sufficiently hot to absorb the stabilizer.
C No, as the stabilizer is always slowly consumed.
Essential components" of the engine means the turbopump, the stabilizer and the regulator.
The stabilizer rods' ball studs are characterized by high fatigue strength.
Damage has been detected in the stabilizer acceleration sensors.
When the stabilizer turns on green LED«Working» gets activated.
This is characterized by a greater thread diameter at the point of junction with the stabilizer: M10 for the Ford Focus II and M12 for Ford Focus III.
I reinforced the stabilizer with 4mm carbon tubes and used generic HobbyKing plastic hinges.
Before doing so, return the Stabilizer to the Factory Preset setting.
The stabilizer attaches on two self-tapping screws,the airplane assembles in 2 minutes in the field.
The stabilizer and the fin are made of balsa, they're not flat and have a symmetrical 10%-thick airfoil.
The stabilizer of 3 points is simple and isomorphic to the projective special linear group PSL34.
M11 is the stabilizer of a point in M12, and turns out also to be a sporadic simple group.
Suddenly, at 10:51:30 the stabilizer angle sharply increased, exceeding the 2° limit.
The stabilizer of a vertex of the graph is isomorphic to the symmetric group S7 on 7 letters.
For Ford Focus 2, depending on the type of the stabilizer being used, there are 2 variants of the rear transverse under-spring arm- straight(FENOX CA21004) and curved new product- FENOX CA21044.
The stabilizer of 3 points is the projective special unitary group PSU(3,22), which is solvable.
The Stabilizer function controls the point at which faint variations in the Threshold begin to be heard.
Knowledge of the stabilizer level in the propellant is essential to identify that ammunition is at risk of this phenomenon.