Приклади вживання Power density Англійська мовою та їх переклад на Українською
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Maximum power density.
Compact structure, light weight and high power density.
Increase power density.
The singlemode laserbeam was greatly increased through focused power density.
Intensity of photo exposure(power density per 1 cm2) 0.1 W from 1 W and more.
The power density of the LT4 makes it one of the smallest and lightest 650-hp engines in the industry.”.
Gray-tracking at high power limited its application to moderate power density.
Most people perceivepink noise as having uniform spectral power density- the same apparent loudness at all frequencies.
The resulting vector has the unitsof power divided by area(i.e., surface power density).
As a result, the power density of TrueNorth is 20mW per square centimeter(a typical modern processor's figure is somewhere above 50 Watts).
A majority of survey respondents(57%) report a data center power density of<10kW per rack.
Reducing power density can limit the effectiveness of your product while adding heat sinks and fans can increase size, weight and cost.
The electrodes are made of precious metals(platinum and palladium) and power density is low. Despite recent commitments.
Fusion power density increases with the square of the pressure-- so doubling the pressure leads to a fourfold increase in energy production.
No melting occurred for both tungsten alloy swagingrod grades after transient heat loading at power density of 0.88 GW m- 2.
Power density for solar panel arrays in deserts can reach 20 W/m2 or even more, and suddenly you're dealing with more manageable fractions of the Earth's surface.
Plutonium-238 has a half-life of 87.7 years, reasonable power density of 0.57 watts per gram,[11] and exceptionally low gamma and neutron radiation levels.
While supercapacitors have specific energy andenergy densities that are approximately 10% of batteries, their power density is generally 10 to 100 times greater.
It indicates how much lower the fusion power density of the other reactions is compared to the D-T reaction and can be considered a measure of the economic potential.
While existing supercapacitors have energy densities thatare approximately 10% of a conventional battery, their power density is generally 10 to 100 times as great.
However, the power density of 241Am is only 1/4 that of 238Pu, and 241Am produces more penetrating radiation through decay chain products than 238Pu and needs more shielding.
Thanks to a specially prepared onlinepayment systems today can determine the power density of floor heating for a few seconds and get the necessary calculations.
According to IBM, the new design could outperform current lithium-ion batteries in cost,charging time(less than five minutes to reach an 80 percent charge), power density and energy efficiency.
This isotope provides phenomenal power density(pure 210Po emits 140 W/g) because of its high decay rate, but has limited use because of its very short half-life of 138 days.
According to IBM, the new design could outperform current lithium-ion batteries in cost,charging time(less than five minutes to reach an 80 percent charge), power density and energy efficiency.
While the air storage system offers a relatively low power density and vehicle range, its high efficiency is attractive for hybrid vehicles that use a conventional internal combustion engine as a main power source.
Consequently, they can have very high efficiencies in converting chemical energy to electrical energy,especially when they are operated at low power density, and using pure hydrogen and oxygen as reactants.
Dielectric capacitors typically have ultrahigh power density, which makes them suitable for high power and pulse power technologies that require accumulating energy over a period of time and then releasing it very quickly.
Looking towards the future, Keshvari expects to extend the measurement range to reach lower andhigher frequencies as well as develop the technology to measure power density, which is being looked at for 5G systems.
The problem is solved by the method of reflexotherapy,which consists in exposing the BAT to the electromagnetic radiation of the infrared range, when the radiation power density on 10- 30% is below the threshold, before the onset of pain.