Примери за използване на Are drilled на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
The uprights are drilled hole axis.
On the edges of the saucer 4 holes are drilled.
In the wall holes are drilled for fixation with screws.
In the place you chose, holes are drilled.
Holes of small diameter are drilled first(no more than 12 mm);
Хората също превеждат
Under these pins in the end of the boards are drilled holes.
Two holes are drilled in each section to connect the structure.
The pressure plate are drilled two holes.
The holes are drilled not less than 40 millimeters from the edge of the sheet;
Some may believe that the holes are drilled in the cheese.
Two threaded holes are drilled on the bottom for fastening to the base of the block.
Then through the additional plate 3 holes are drilled on the main surface.
Boreholes are drilled regularly spaced depending on the wall thickness.
Smooth, holes for fastening which are drilled during the installation.
In the ends of the clamp cutoff at 45 degrees, holes of large diameter are drilled.
Some may think that the holes are drilled in the cheese. That's not true!
Two holes are drilled in these plates, which should be coaxial with the holes made in the block.
According to these sizes,grooves are drilled in 3.5 mm, 4 mm and 4.5 mm.
If the capsules are drilled or cracked, immediately wash your hands thoroughly with soap and water.
In order to fix the hubs on the disc, 4 holes are drilled on each of them.
Two threaded holes are drilled at the bottom of the case for attachment to the base.
For studs, you need a 10 mm drill bit, they are drilled all the boards at once.
For this purpose, the position of the buttons is marked on the chipboard sheet, and thin holes are drilled.
Along the length of the channels, holes are drilled at a distance of 1-1.5 m from each other.
In this case, a combination of vertical and horizontal drainage is used(trenches are laid,wells are drilled).
Under the support pillars, holes are drilled or drilled in the earth to a depth of 800 mm.
For the columnar foundation, too, markings are made, andthen holes are drilled for future pillars.
In several places of both squares, holes are drilled symmetrically into which the clamp screws are inserted.
Instead, the chicken-out point is the marginal cost of production, orthe additional costs after the wells are drilled and the pipes are laid.
In it, at an equal distance, through holes are drilled, to fasten the lengths of the line, the thicker the holes.