Примери за използване на Directivity на Английски и техните преводи на Български
{-}
-
Colloquial
-
Official
-
Medicine
-
Ecclesiastic
-
Ecclesiastic
-
Computer
Directivity: Heart type.
The high frequency signal below 1.5kHz has obvious directivity.
Directivity Characteristic: Cardioid.
Each zone has its own light source,adjustable directivity.
Directivity encourages the mastery of specific knowledge and the improvement of its level.
Laser lightning of the center of directivity diagram.
This creates the directivity of the antenna and the concentration of the signal in one direction.
The LG V10 has an advanced audio recording system,which includes 3 microphones with controllable directivity.
Equipped with tailored diaphragm and precise directivity, TM58 series give full and powerful sound.
Tights with directivity tightening effect in the zone footwell. Made of fine fabric with 12% Lycra with density 40 deniers.
The characteristics of LED street lamps themselves-- single directivity of light, no diffusing of light, guaranteed illumination power;
Single mode Low insertion loss Large directivity Minimal polarization dependence Environmentally stable.
Speakers of the performance indicators are rated power, rated impedance, frequency characteristics, harmonic distortion,sensitivity, directivity and so on.
This improves sonic directivity to the listening area, giving music more focus while preserving tonal accuracy.
Speakers for different directions of radiation, the sound pressure frequency characteristics are different,this feature is called the speaker of the directivity.
Here the space of mind can be compared with an electricity conductor,where the electrons being disordered, attain directivity(and that for example can also be used for supplying of different appliances).
It will reduce the sectional area between the bit blade and rock hole,aslo solve the problem of large diameter's low drilling footage in the hard formation with good directivity.
Some decorative materials can be deformed with direct light directivity, for example, stretch ceilings and unfolded chandelier ceiling in the bedroom(photos of such models can be seen in our catalog) will not be relevant here;
The health is on itself a noble goal for each human, butit must not be forgotten that in Yoga the practices are made with another directivity, and namely the self-knowledge.
Switching potential input has directivity, you should connect the common end with the positive terminal of potential, and connecting the input end with negative terminal of potential for ensuring the potential of common end is higher than the one of input end.
However, in the case of high-power LEDs containing blue wavelengths in the emission spectrum, there are LEDs that will be classified as Risk Group 2 depending on the characteristics(e.g. radiation flux,emission spectrum, directivity, etc.).
ECM-B1M Shotgun Microphone[xxi]- Eighthigh-performance mic capsules and advanced digital signal processing provide three selectable directivity patterns in one compact microphone of approximately 99.3mm(4 inches) in length with Super-directional pick up;
Laser and a high coherence, high strength,high directivity, laser passing by laser-produced by the mirror and by gathering mirror shine on the processed goods, processed goods(surface) sharp increase in intense heat and temperature, so quickly because of the high temperature melting or vaporization of the point, with the trajectory of the laser head so as to achieve the purpose of processing.
Thanks to high frequency of probing signal andeffectively implemented narrow diagram of antenna directivity“LORNET- 36” is considerably better than all domestic and foreign nonlinear detectors in range of detection, selection and accuracy of spatial localization of semi-conductor elements.
Laser at the same time with high coherence, high strength,high directivity, the laser generated by the laser transmitted by the mirror and through the collection mirror to the processing of objects, so that the processed objects(surface) by the strong heat and the temperature increased dramatically, So that the point due to high temperature and rapid melting or vaporization, with the trajectory of the laser head to achieve the purpose of processing CNC cutting machine.