英語 での The set value の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
The set value is PEAP, TLS.
Response Less than 1 sec. for±2% of the set value.
Check the set value of air regulator.
When the distance is over the set value, an error occurs.
Using the set value, it accesses Twilio API and sends SMS.
Enter the target quantity and automatically stop at the set value.
Input exceeding the set value can not be performed.
SAMBA, the set value of the domain.
If no obvious moving in scope,the bitrate will be reduced to 50% of the set value automatically.
If it does not exceed the set value, deletes the E entry(step S 24).
It is not surprising tofind that the voltage across the capacitor is around 10% of the set value.
If the argument is empty, use the set value of the management screen.
Enables to watch the folders andarchive them automatically when the capacity exceeds the set value.
When each function is selected, the set value of the selected function is displayed in the slide.
Bag length adjuster is to adjust the corner sealing to the proper position when the set value of the bag length changes.
Protection: When the force exceeds the set value(such as 40 kg), arm can rotate in order to protect.
Operation reaches the set value, the machine automatically shut down, while the counter stops counting, and automatic shutdown.
When the temperature of the collector reaches the set value, the controller starts the. .
B, 2c simulated load, the set value should be lower than the allowable pressure of the valve under test.
Frying Temperature andTime Setting→ Start Heating Until the Oil Temperature Reaches the Set Value and Start Feeding→ Frying→ Continuous Production.
For safety protection only, the set value should not exceed the allowable pressure of the testing valve.
Automatic control inside the test roomAutomatic control system that can operate up to the set value with the maximum ability and can maintain with minimum effort after reaching the set value. .
Surge voltage higher than the set value may be applied at the time of voltage application, depending on the device.
The[Interval] may be longer than the set value depending on the shutter speed setting and other camera settings.
When the machine running reach the set value, can automatically stop work and the counter stop recording the times.
However, if the air pressure is lowered with the set value of the standard pressure as it is, a warning of insufficient air pressure is given.
In the Edit terminal strip dialog, the set value for the switching jumpers is displayed in the Switching jumper(external) column.
When the coulomb counter reaches the set value, it alerts the microcontroller to stop charging because the battery is fully charged.
Power-on again after making sure that the set value of parameter[111]‘Weighing Signal Type' and the switch position of DIP1/DIP2 are matched with the actual weighing input signal.