英語 での Wireless clients の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Number of wireless clients per switch/stack 1000.
Yes, you can use ASA/PIX as a DHCP server for wireless clients.
O Number of wireless clients per switch/stack: 2000.
The virtual interface IP addressis only used for communications between the controller and wireless clients.
Configure 802.1X wireless clients by using Group Policy.
Wireless clients have both CLI and GUI access with the dynamic interface.
Note: The internal DHCP server only works(for wireless clients) with DHCP proxy enabled.
Wireless clients have both CLI and GUI access with the dynamic interface.
Support for up to 50 access points and 1000 wireless clients on each switching entity(switch or stack).
The wireless clients always attempt to transmit and receive at the highest possible data rate.
Support for up to 100 access points and 2000 wireless clients on each switching entity(switch or stack).
If all the wireless clients belong to the same VLAN, you can configure the switch port as an Access port.
I decided to use the internal DHCP feature of this WLC but my wireless clients do not get IP addresses from the WLC.
Video delivery to wireless clients is at the highest mandatory data rates on the respective channel.
I decided to use the internal DHCP feature of this WLC but my wireless clients do not get IP addresses from the WLC.
All wireless clients requesting to join a stream will be assigned video QoS priority on admission.
LAPs registered to a WLC lose their association to the WLC, so service to the wireless clients is interrupted.
With Preauthentication, the wireless clients can authenticate with multiple APs at a time while associated with the current AP.
Note: The Bonjour ACL willonly filter inbound multicast traffic from wireless clients to the wired network.
Lightweight access points(LAPs), which serve the wireless clients, register themselves to the WLC and download the entire configuration from WLC.
Cons with CCKM CCKM is a Ciscoproprietary method, which limits the implementation and support to Cisco WLAN infrastructure and CCX wireless clients.
Thus, you must select thebest method that is actually supported by the wireless clients that connect to the specific WLAN/SSID.
Wireless clients can access the WLC only when the optionEnable Controller Management to be accessible from Wireless Clients is checked.
We have a couple of Access Control Servers(ACS) that authenticate the wireless clients associated to wireless LAN controllers(WLCs).
This method has a big limitation on its implementation: Wireless clients can only perform fast-secure roaming when roaming back to an AP where they had previously authenticated/connected.
Integration of the VLAN select feature also introduces someissues in current multicast architecture where wireless clients can receive duplicate packets.
You should not connect servers, such as DHCP, TFTP, and so on,on these ports and expect Wireless Clients and APs to receive an IP address from this DHCP server.
The integration of the VLAN Select feature also introduces someissues in current multicast architecture where wireless clients may receive duplicate packets.
You should not connect servers, such as DHCP, TFTP, and so on,on these ports and expect Wireless Clients and APs to receive an IP address from this DHCP server.