英語 での Wireless client の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
MAC address of wireless client.
Wireless Client gets associated with the Access Point(AP).
Phase 1. Initiate wireless client to Rogue AP.
Wireless client- The software that controls a wireless adapter.
These directions are taken from a position relative to the WLC andnot the wireless client.
The roaming event is initiated by the wireless client once it considers it should roam.
The wireless client begins with the Authentication frame, and the AP replies with another Authentication frame.
If not, users can uncheck the DHCP Required check box on the WLAN andgive the wireless client a static IP address.
See the Connectivity Problems- Wireless Client to AP/Base Station(Radio Link) section of this document.
The MAG(that is, controller) interfaces with the LMA,and performs the mobility management on behalf of the wireless client MN.
The wireless client performs fast-secure roaming to a new AP on the same WLAN/SSID, even if it never associated with that AP.
How to debug client associationissues The AP joins the controller properly, but the wireless client cannot associate with the Corporate SSID.
Here, the wireless client performs fast-secure roaming to a new AP on the same WLAN/SSID, even if it never associated with that AP not the case in SKC.
The repeater encryption Configuration< network< Repeater set andthe previous function MAC filtering is now referred to as a wireless client approval.
Specifically, the wireless client implements the installation of PTK immediately after receiving Message 3, but this is before the completion of 4way handshake.
The Wi-Fi Alliance is a nonprofit organization founded in 1999 thatbrings together an assortment of chipset vendors, wireless client vendors, and access point vendors.
When the wireless client moves its association from one AP to another, the controller simply updates the client database with the newly associated AP.
The Cisco WLAN Solution Management over Wireless feature allows Cisco WLAN Solution operators to monitor andconfigure local WLCs using a wireless client.
The wireless client and APs must remember all of the PMKs derived on every new authentication, so this feature is normally limited to a certain amount of PMKs that are cached.
Other device on the network(defined as CN)will be able to reach the wireless client(MN) via its home address through the LMA, which is advertising the reachability for the MN prefix to the CN.
Wireless client adapters connect a variety of devices to a wireless network either in ad hoc peer-to-peer mode or in infrastructure mode with access points.
Currently, traffic sources from a Layer 3 roamed wireless client is put on the dynamic interface assigned on the WLAN or the interface of the AP Group VLAN….
Fast roaming is achieved by caching a derivative of the master key from a full EAP authentication so that a simple andsecure key exchange can occur when a wireless client roams to a different access point.
When a wireless client attempts to associate to a lightweight access point, association response packets are sent to the client with an 802.11 response packet including status code 17.
One of our clients noticed that in our new AT870N handheld reader,the Summit Wireless client which manages WIFI connections on the device had a different look than in the old AT870.
When an 802.11 wireless client connects to an Access Point(AP), before it begins to pass traffic(wireless data frames), it first must pass the basic 802.11 Open System authentication process.
This document explains variousissues that you can encounter when you connect a wireless client in a Cisco Unified Wireless environment, as well as the steps to be taken to troubleshoot and resolve these issues.
When a wireless client attempts to associate to a lightweight access point, association response packets are sent to the client with an 802.11 response packet including status code 17.
First is stationary infrastructure in which the fast roaming wireless client will interoperate, and the second is mobile infrastructure consisting of the wireless roaming client itself.
Pros with Opportunistic Key Caching The wireless client and the WLAN infrastructure do not need to remember multiple PMKIDs, but simply cache the one original PMK from the initial authentication to the WLAN.