Exemplos de uso de Collector array em Inglês e suas traduções para o Português
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
-
Official/political
Measures the temperature of the Collector Array.
No 0% Is the Collector Array to face more than 90 Yes 5% from the equator?
Check that there are no obstructions to the Collector Array.
The method of connection to the Collector Array was described previously.
Alternate layout with Headers at opposite ends of the Collector Array.
This will ensure that the Collector Array does not fill with gas from the chlorinator.
The return line is connected to the highest point of the Collector Array.
Uniform water flow across the Collector Array area is promoted.
The supply line is connected to the lowest point of the Collector Array.
This will ensure that expansion in the Collector Array will not damage the connections.
Measure the roof andcheck against the area and size of the Collector Array.
Wherever possible the Collector Array should be installed as a contiguous unit.
This will prevent particles entering the Solar Pump and collector array.
This allows controlled drain back of the Collector Array without damage to the Solar Pump.
This sensor is placed in a position which receives the same radiation as the Collector Array.
The roof space available to install the Collector Array may be below that which is recommended here.
The Supply andReturn Headers should run parallel to each other at the same end of the Collector Array.
Best performance is achieved when the Collector Array is positioned in accordance with the above guidelines.
The 40 mm supply andreturn lines should now be run from the Solar Pump to the roof mounted Collector Array.
One sensor measures the temperature at the Collector Array while the other measures the pool water temperature.
A Check Valve should be fitted between the Solar Pump suction line andthe return line from the Collector Array.
When the Solar Pump is OFF the water does not pass through the Collector Array although the filter may continue to operate.
Maximum Collector Array area can usually be fitted since the layout is not constrained by valleys or corrugations.
Deviations from this will increase the amount of Collector Array area required.
The Collector Array return line connects after the Collector Array supply line and before any chlorinator.
Measure the pool andcheck against the Final Ratio of Collector Array to pool surface area.
The return line from the Collector Array should be connected after the Solar Pump suction line and before the chlorinator if fitted.
The diagram below shows the Minimum Basic Ratios of Collector Array to pool surface area for Australia.
Yes, solar hot water project is a large-scale solar heating system to provide hot water with solar collector array.
When the Solar Pump is ON,water is pumped from the swimming pool through the Collector Array and is heated before being returned to the swimming pool.