Examples of using Frequency response in English and their translations into Bengali
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Frequency Response(±3 DB).
These Line Array Subwoofer Speakers are wired at 4 Ohms andhave a frequency response of 40Hz- 280Hz.
Frequency Response: 50Hz-350Hz.
The digital control servo system has the speed and frequency response of more than 400Hz, and the speed fluctuation rate is<0.03.
Frequency Response: 60Hz -20kHz.
The electroacoustic parameters of hearing aids include gain, frequency response, compression ratio, number of channels, and so on.
Frequency response: 300Hz-3KHz;
Feature description: No-head roughness sensor, good frequency response characteristics, wide signal bandwidth, is the best roughness sensor type.
Frequency Response: 50 Hz-18000 Hz.
The sound is generally very clear, rich in detail, low frequency response is very good, for most people closed headphones wearing a sealed only sense.
Frequency Response Range: 20-20000Hz.
Sound is generally very clear, rich in detail, low frequency response is very good, for the majority of people who are closed type headphones wear a sealed only.
SQ-226P line array is a mini active two way system,which provides 80Hz-18KHz frequency response, with flat frequency and phase response. .
MIC I/O frequency response(±3dB).
In the selection of microphone, besides the sensitivity of microphone, the matching of output impedance and input impedanceof mixer, the directional characteristics, frequency response characteristics and the shape of microphone should also be considered in the conference room.
By comparison, the sensitivity, frequency response, distortion degree and other indicators of similar portable acoustic devices are lower than this product.
SH-25 is one full range passive loudspeaker with strong power and good frequency response, the Cabinet is suspension point and rack available for suspension and mounting.
As far as the frequency response characteristics of microphones are concerned, microphones with low static skill objectives and good transient characteristics are better than microphones with slightly higher static skill objectives and poor transient characteristics.
Below this critical value, there is a single peak in the frequency response with the amplitude peaking at resonance and the peak decreasing as k decreases.
This product is designed based on the frequency response characteristics of human voice and according to the characteristics of acoustic phase interference to suppress acoustic feedback.
The average manufacturer is to reduce theoutput amplitude by 1/2 to the standard measured frequency response width, which is to say -3dB, but because of the different test standards used, some products are measured at -10dB.
December 14, 2017This product is designed based on the frequency response characteristics of human voice and according to the characteristics of acoustic phase interference to suppress acoustic feedback. It integrates… view.
When selecting conference microphones, capacitive microphones with wide frequency response, uniform transmission characteristics, smoothness and low distortion should be generally chosen.
The farther the mouth goes against the middle axis, the worse the frequency response characteristics, the more severe the loss of treble, and the output voltage of the microphone will be reduced.
The built-in 4.5”x4 four wayspeaker drivers are designed of wide frequency response 140-12kHz, the power output of 15W could meet different applications varies from room size and ambient noise surroundings.
The built-in 4”x3,2.5”x1 two way speaker drivers are designed of wide frequency response 140-14kHz, the max power 60W could meet different applications varies from room size and ambient noise surroundings.
The average manufacturer is an outputamplitude reduction of 1/2 as the standard measured frequency response width, which means that -3dB as the standard, but because of the different test standards used, some products are measured at -10dB.
The built-in 4”x1,2.5”x1 two way speaker drivers are designed of wide frequency response 140-14kHz, the power output of 10W could meet different applications varies from room size and ambient noise surroundings.
Manufacturers in general is an output amplitude reduced by1/ 2 as the width of the standard measure frequency response, that is to say in order to-3db as the standard, but due to the difference of the testing standards, some of the products is to- 10 dB for the measurement of.
D6558 Desktop Condenser MicrophoneDecember 14,2017This product is designed based on the frequency response characteristics of human voice and according to the characteristics of acoustic phase interference to suppress acoustic feedback. It integrates… view.