Examples of using Bus controller in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
Bus Controller.
Universal Serial Bus Controllers.
The Bus Controller.
总线控制器.Universal Serial Bus Controller.
通用串行总线器Universalbus.The Bus Controller.
则总线控制器.This means that the Remote Terminal(RT)number 3 has responded to the Bus Controller query after 8.97 us.
这意味着远程终端3在总线控制器查询的8.97微秒后响应。The Bus Controller.
着总线控制器.If the drive is not seen there,check under Universal Serial Bus Controllers(if the drive is connected via USB).
如果没有看到移动硬盘，请检查“通用串行总线控制器”（如果驱动器通过USB连接）。Bus Controller Remote Terminal.
总线远程终端器.PLDA designs and sells a wide range of ASIC andFPGA interconnect solutions including bus controllers and SoC IP.
PLDA设计并销售种类广泛的ASIC和FPGA互连解决方案，其中包括总线控制器和SoCIP。Bus Controller Remote Terminal.
总线控制器远程终端.To do this, you must first of all set the number of bus controllers(CRP 811 00) used in the Select Extensions dialog.
要做到这一点，您必须首先在SelectExtensions对话框中设定所使用的总线控制器(CRP81100)的数目。The Bus Controller sends one command word to Remote Terminal.
总线控制器向远程终端发送一个发送命令字。Its primary role is to monitor and record bus transactions,without interfering with the operation of the bus controller or the RTs.
它的主要作用是监视和记录总线事务，而不会干扰总线控制器或RT的操作。The Bus Controller sends one transmit command word to a Remote Terminal.
总线控制器向远程终端发送一个发送命令字。The AMD 750 chipset consists of two physical devices:the AMD-751 system controller and the AMD-756 peripheral bus controller.
这个芯片组由两个部分组成，分别是AMD-751系统控制器和AMD-756外围总线控制器。Generally, this causes the Bus Controller to transmit a Transmit Vector Word Mode Code command.
通常来说，这使总线控制器发送“传送向量字模式代码”命令。Also, while you are in the above-mentioned Device Manager category, you could try andsearch for driver updates specifically for USB(Universal Serial Bus controllers).
此外，当您处于上述设备管理器类别时，您可以尝试搜索专门针对USB(通用串行总线控制器)的驱动程序更新。The Bus Controller sends one 16-bit receive command word, immediately followed by 1 to 32 16-bit data words.
总线控制器发送一个16位接收命令字，紧随1到32个16位数据字。Alternatively, a BM is used in conjunction with a Backup Bus Controller. This allows the Backup Bus Controller to"hit the ground running", if it is called upon to become the active Bus Controller.
或者，总线监控器可以与备用总线控制器结合使用。这允许备用总线控制器“调到正常运行”{{what}}，如果它被调用成为活动总线控制器。The Bus Controller sends one command word with a Sub-address of 0 or 31 signifying a Mode Code type command.
总线控制器发送一个命令字，子地址为0或31，表示“模式代码”类型命令。This means that the Bus Controller has to poll all the Remote Terminals connected to the data bus, generally at least once in a major cycle.
这意味着总线控制器必须轮询连接到数据总线的所有远程终端，通常在主要周期中至少轮询一次。The Bus Controller receives RT1's status word, and sees that the transmit command has been received and actioned without a problem.
总线控制器接收RT1的状态字，并且看到发送命令已经接收，并且操作无误。There is only one Bus Controller at a time on any MIL-STD-1553 bus. It initiates all message communication over the bus. .
The Bus Controller receives RT2's status word and sees that the receive command and data have been received and actioned without a problem.
总线控制器接收RT2的状态字，并且看到接收命令和数据已经无误接收和操作。The Bus Controller sends one receive command word with a Terminal address of 31 signifying a broadcast type command, immediately followed by 0 to 32 data words.
总线控制器发送一个接收命令字，终端地址为31，表示广播类型命令，后面紧随0到32个数据字。The Bus Controller sends out one receive command word with a Terminal address of 31 signifying a broadcast type command, immediately followed by one transmit command.
总线控制器发出一个接收命令字，终端地址为31，表示广播类型命令，紧随一个发送命令。It adopts a newbus architecture known as Advanced Micro controller Bus Architecture(AMBA).
它采用了新的总线架构AdvancedMicrocontrollerBusArchitecture(AMBA)。It adopts a newbus architecture known as Advanced Micro controller Bus Architecture(AMBA).
同样它还采用了AdvancedMicrocontrollerBusArchitecture(AMBA)新型总线结构。They include a CPU, GPU, bus system and interface controller.
