Examples of using External interrupt in English and their translations into Chinese
{-}
-
Political
-
Ecclesiastic
-
Programming
Via an external interrupt.
This bit sets the masking of external interrupt 1.
External interrupt 1 priority bit high.
Up to 32 external interrupts.
Processor wake-up from Power-down mode via external interrupt.
Internal and external interrupt sources.
Set/cleared by software to specify falling edge/low level triggered external interrupts.
Internal and 2 external interrupts.
An external interrupt event will wake the processor and the peripherals.
Three internal and two external Interrupts.
Up to 27 external interrupts on 6 vectors.
This bit sets the priority of the External Interrupt 1 interrupt. .
Up to 27 external interrupts on 6 vectors.
This bit sets the priority of the External Interrupt 1 interrupt. .
Three external interrupts may be configured to terminate Power-down mode.
The PC7 pin can serve as an external interrupt source to the.
If ITx= 0, external interrupt x is triggered by a detected low at the INTx pin.
Of these there are 16 Analog inputs, 12PWM outputs,and 6 external interrupts available.
All mappable on 16 external interrupt vectors and almost all 5 V-tolerant.
Hardware Interrupts- They occur in response to an external event, such as an external interrupt pin going high or low.
If the external interrupt request is not enabled, SLEEP is active also for these pins.
The standard Arduino has two external interrupts on digital pins 2 and 3.
Wake-up sources include external interrupts, the power-fail interrupt, and a timer interrupt. .
The AT89LP216 provides 7 interrupt sources: two external interrupts, two timer interrupts, a.
In shutdown mode, only an external interrupt can wake up the device.
Arduino UNO supports two external interrupts, on digital pins 2 and 3.
In hibernate mode, peripherals such as external interrupts or the internal wake-up timer can wake up the device.
In this mode, the external Oscillator is stopped, while the external interrupts, the 2-wire Serial Interface address watch, and the Watchdog continue operating(if enabled).
Several external and internal interrupts and RESET.
Several external and internal interrupts and resets.