Examples of using Test points in English and their translations into Croatian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
These test points can be holes or pads.
The laps of testing you carry out generate Test points.
Test points can not be selected on the solder joints of the components.
Gold fingers are not used as test points to avoid damage.
The test points should be 3 cm away from the edges of the joints and the shunt connection.
Within 32mm of the shape, there must be no components or test points.
Test points to likely influence of click-through rate on search rankings.
When setting test points on the wires of the circuit, the width can be enlarged to 40 mils.
Once the resistors are in, install PC stakes at the antenna output andthe TP GND and TP1 test points.
The test points should not be covered by solder resist or text oil ring, otherwise the small test points will be connected.
Positioning hole ring Within 32mm of the shape, there must be no components or test points.
It contains thecomponent designators,switch settings, test points and other indications helpful in assembling,testing and servicing the circuit board.
A technique has been describedwhich opens up windows in the solder mask to create test points located directly on PCB tracks.
In the ICT test, the test probe contacts the test points on the PCBA board, and faults such as short circuit, open circuit, and component soldering can be detected.
What follows is a fully automatic process which turns the test points into car character points. .
A: These are the Power, Handling andAcceleration attributes of the car according to the part levels you have and any test points you have gained.
A technique has been described[8]which opens up windows in the solder mask to create test points located directly on PCB tracks.
A bed of nails tester is a traditional electronic test fixture which has numerous pins inserted into holes in an epoxy phenolic glass cloth laminated sheet(G-10)which are aligned using tooling pins to make contact with test points on a printed circuit board and are also connected to a measuring unit bywires.
A bed of nails tester is a traditional electronic test fixture which has numerous pins inserted into holes in an epoxy phenolic glass cloth laminated sheet(G-10)which are aligned using tooling pins to make contact with test points on a printed circuit board and are also connected to a measuring unit by wires.
A bed of nails tester is a traditional electronic test fixture which has numerous pins inserted into holes in an epoxy phenolic glass cloth laminated sheet(G-10)which are aligned using tooling pins to make contact with test points on a printed circuit board and are also connected to a measuring unit by wires.
Test point, and flat contacts by merely exchanging a sample holder.
DNA tests points to your daughter as the killer.
Otherwise, the test fixture probe will be in poor contact with the test point.
The probe test supports the via and the test point.
The difference is the cable wave speed, which gives the distance between the fault point and the test point.
But in mass production, test point diameters of 1.0mm or higher are normally used to minimise contact failures leading to lower remachining costs.
The position of the double cursor can be arbitrarily changed, and the direct distance orrelative distance between the fault point and the test point is directly displayed.
But in mass production, test point diameters of 1.0mm or higher are normally used to minimise contact failures leading to lower remachining costs.
