Examples of using An ethernet in English and their translations into Czech
{-}
-
Colloquial
-
Official
Using the printer over an Ethernet network.
An Ethernet cable. What, that attaches to the device?
Connect your PC to the modem using an Ethernet cable.
An Ethernet connection exists between MultiControl and computer.
The devices feature an Ethernet and a USB interface.
People also translate
One isn't supplied in the box,neither is an ethernet cable.
Connect an Ethernet cable to Private Port on the rear panel.
To connect to a home network using an Ethernet cable.
Connect an Ethernet cable to the LAN1~LAN4 Port on the rear panel.
Connect your PC to the Access Point(AP) using an Ethernet cable.
Connect an Ethernet cable from the modem to the router's WAN port.
Information you will need to set up the printer on an Ethernet network.
Description PROFINET IO is an Ethernet based communications protocol.
Using an Ethernet cable, connect a computer directly to the LAN adapter.
The equipment is easy to use andcan be networked via an Ethernet interface.
Attach an Ethernet cable to the Ethernet port on the DUB-1312.
Our heaters can be connected to a central control unit by means of an ethernet cable.
Connect an Ethernet cable between your computer and the Wireless Access Point.
Connect your DSL/cable modem orwired Internet line to the DIR-510L with an Ethernet cable.
Plug an Ethernet cable into the Ethernet connector on the media player.
Plug an Ethernet cable into the Ethernet connector on the media center.
The hardware and software components allow direct networking ofall connected sensors and actuators with a local server via an Ethernet network.
Equipped with an Ethernet port, it enables access to RSS feeds and weather forecasts.
And even in the middle of nowhere, and point it at the tower, you can connect to the world.the copper wire as an Ethernet cable, Add a drill bit as the receiver.
The green light turns on when an Ethernet device is connected and active on this port.
An Ethernet cable from your computer should be connected to a LAN port on the back of the router.
Use an ethernet cable to connect each of the units to a PoE source and connect a PC to one of them for configuration.
The extension module NTLog Comfort can also be connected using an Ethernet connection to a computer in the same local network so that data can be written directly onto this computer.