Examples of using Default gateway in English and their translations into Czech
{-}
-
Colloquial
-
Official
That's the default gateway.
The“Default Gateway” entry is typically the access point.
Gateway- IP address of the default gateway.
Enter the Default Gateway, Subnet Mask.
Otherwise, enter the IP address,subnet mask and default gateway manually.
To enter"Default Gateway", set[RA(Stateless)] to Off.
Installing and Setting up the Machine>Network Setup 11Set the default gateway.
Default Gateway: Enter the Gateway assigned by your ISP.
Gateway- IP address of a default gateway- assigned by a network administrator.
Touch MANUAL SETTINGS, and then enter the IP ADDRESS,SUBNET MASK, and DEFAULT GATEWAY.
The default gateway is stored and the IPv4 Setting menu reappears.
Out-of-Band Ethernet Management Port default gateway address.
Gateway- IP address of default gateway, allocated by the network administrator.
Wait a moment until your computer has received the parameters IP address,subnet mask, default gateway.
Obtain a valid IP address, subnet mask, and default gateway from your system administrator.
The default gateway(next hop router) IP address for configuring the default route.
The settings of IP Address,Subnet Mask and Default Gateway must correspond with your camera and networking settings.
If your home wireless network has been configured to use specific IP Addresses,Subnet Mask, Default Gateway, Primary DNS, etc.
Entering the Default Gateway When DHCP is set to Off, enter the Default Gateway manually.
When entering an IP Address manually, check the IP Address,Subnet Mask and Default Gateway with the system administrator.
The Default Gateway, Subnet Mask, and DNS address settings can be entered via CentreWare Internet Services if the device is on the same subnet as the workstation.
The IP address of the Out-of-Band Ethernet Management Port default gateway for configuring the default route.
When using the fixed IP by changing the default settings, contact the system administrator tocheck the IP address, subnet mask and default gateway.
Value IP Address:(numbers(128 bit in total) separated by colons) Prefix Length:0 to 128 Default Gateway: numbers(128 bit in total) separated by colons.
Mask for service access, 24 by default. Netmask Default gateway for service access, empty by default. Gateway Allowing access via HTTP server for HTTP and HTTPS protocol.
Use the MANUAL SETTINGS menu and your control-panel keys to set the values for IP ADDRESS,SUBNET MASK, DEFAULT GATEWAY, SYSLOG SERVER and IDLE TIMEOUT.
Mask for service access, 24 by default. Netmask Default gateway for service access; empty by default. Gateway Enables access via VLAN management.
Use the MANUAL SETTINGS menu and your control panel keys to set the values for IP ADDRESS,SUBNET MASK, DEFAULT GATEWAY, SYSLOG SERVER, and IDLE TIMEOUT.
In case no external access to the installation is nec- essary, the default gateway can be set to 0, in this way blocking any communication to the internet.
If the network you're connected to doesn't support DHCP select“Static IP” as your connection type and manually enter the IP address,subnet mask, default gateway and DNS server information.