Examples of using Switch-off time in English and their translations into Czech
{-}
-
Colloquial
-
Official
The previously saved switch-off time is retained.
The switch-off time of 60 minutes appears on the display.
The timer switches the device off when reaching the switch-off time.
When setting the switch-off time, please proceed in the same way as described above.
Use the arrow keys 23 to select a switch-off time of 1 to 24 hours.
Switch-off time equals to digit x 10 min setting range 10 to 90 min.
TIMER button(N) Press the TIMER button(N)to set the switch-off time.
The switch-on and switch-off times are set on the roof air conditioner.
Pressing the SLEEP button 9 repeatedly reduces the switch-off time by 10 minutes each time. .
Now press the start button(10) repeatedly until the required number of LEDs light up to indicate the switch-off time.
Press the SLEEP button 9 until the desired switch-off time is shown in the display.
After setting the switch-off time, touch the Timer sensor again to confirm and start time count.
If the time is set to 0 seconds, dosing runs continuously until the switch-off time(7.3) elapses.
You can choose between 3 switch-off times automatic switch-off after 1 to 3 hours.
Setting the language 126 13.2 Setting the coffee temperature 127 13.3 Setting the switch-off time 127 13.4 Setting the jug programme.
Using a SCR switch-off time at zero transient current, along with the transformer secondary high voltage and open-circuit voltage, the researchers developed a controlled break.
In this programming step, specify a switch-off time of between 0 and 999 seconds per pulse.
Timer for all programmes: These values(1- 24 hours) fl ash for 5 seconds if you defi ne a switch-off time using the arrow keys.
You switch to the function switch-off time see S. 10 chapter AOT Switch-off timer.
Anti-cycling period during space heating operation 0 min~15 min 5 min Minimal switch-off time in space heating operation.
To use the timer function, touch the Timer sensor while the hood is running(the display shows flashing digit„0”),then use sensors+ or- to select the desired switch-off time delay.
If no button is pressed within 90 seconds, the appliance switches to stand-by mode without saving the new settings. In this case,the previously saved switch-off time is retained.
