Examples of using The wireless router in English and their translations into Czech
{-}
-
Colloquial
-
Official
Did you get the wireless router?
Then, connect a PC to one of the other ports on the wireless router.
Plug in the wireless router and make sure it's turned on.
Earl, I need to get the wireless router.
Refer to the wireless router's documentation to check your network settings.
People also translate
Did you turn on the wireless router?
Refer to the wireless router or access point's documentation to check your network settings.
Press the SES button on the wireless router.
Try moving closer to the wireless router or access point and repeating the scan procedure.
DIR-505 will automatically connect to the wireless Router or AP.
The wireless router is supplied either in a plastic or metal casing, based on the requirements of the customer.
There's a good chance that the wireless router will configure itself automatically.
The wireless router works with most USB HDDs/Flash disks up to 2TB and supports read-write access for FAT16, FAT32, EXT2, EXT3 and NTFS.
I took the wireless router used by the club's credit card point of sale system, and with a minor adjustment, voila.
For the best front-to-rear coverage, place the wireless router in an upright position.
Place the wireless router in a centralized area for a maximum wireless coverage for the network devices.
For the best up-and-down coverage,place the wireless router in an inclined position.
Push WPS button of the wireless Router or AP, and then push and hold the WPS button of DIR-505 for 5 seconds.
Because the wireless router performs many other tasks besides assigning addresses, it sometimes does not respond quickly enough with an address.
A computer with wired Ethernet connection to the wireless router is required for this fi rst-time confi guration.
If your printer or device has not yet been configured for wireless connection andyou want to configure it using WPS, then push the WPS button on the wireless router.
Web interface provides detail statistics about the wireless router activities, signal strength, detailed log, etc.
Most wireless networks use a DHCP server(Dynamic Host Configuration Protocol) built in to the wireless router to assign IP addresses to clients on the wireless network.
And this is where Boston rapid transit keeps the wireless routers that control the signal lights and the switches for the West Side.
However, if you're attempting to connect a wireless router to your cable modem, FiOS gateway or DSL modem, this is a two-device setup; in this case,you will need to leave the wireless router out of the setup first, and connect the other device directly to the computer and the Internet.
Press the WPS button on the wireless network router.
This unit is communicating with the wireless network router.
Try moving this unit closer to the wireless network router.