Examples of using Configuration commands in English and their translations into French
{-}
-
Colloquial
-
Official
Where should I put the configuration commands?
Use these configuration commands to configure AP A.
Recording a sequence of configuration commands.
These global configuration commands can be used in order to enable this feature.
Where must I write the plip configuration commands?
Some can receive configuration commands and some are transmit only.
Built in SPI FLASH,Used to save configuration commands.
Enter following configuration commands one line at a time.
These commands are all interface configuration commands.
Direct access to configuration commands in the authoring applications.
Standards based IPsec tunnels,93% fewer tunnel configuration commands needed..
These configuration commands are only accepted when the access point is in Standalone mode.
Cisco configure terminal Enter configuration commands, one per line.
The configuration commands may be received in packets transmitted across the network and addressed to the router 10.
Therefore, this scheduler requires no configuration commands for activation.
The SPAN feature configuration commands are similar on the Catalyst 2950 and Catalyst 3550.
Automated configuration backups,password changes and scripted configuration commands.
This document explains the configuration commands to change the modulation profile.
Standard configuration applies to protocol and media configurations, as well as global configuration commands.
In order to view sample configuration commands, refer to Configuring HSRP.