Examples of using Bootloader mode in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
See how to get into the bootloader mode below.
Sets the bootloader mode and returns the status after the requested mode change was instigated.
You can only write firmware in bootloader mode.
Returns the current bootloader mode, see SetBootloaderMode.
A Brick can only be flashed if it's in bootloader mode.
If the Bricklet is in bootloader mode, the LED is will show heartbeat by default.
To flash a new firmware the Brick has to be into bootloader mode.
If the Bricklet is in bootloader mode, the LED is off.
It is possible that you accidentally brought your Brick in the bootloader mode.
Returns the current bootloader mode, see nfc_set_bootloader_mode.
In this case the Master Extensionneeds to be disconnected from the stack to make the bootloader mode work correctly.
Transmitter will boot up in the special bootloader mode where you can perform the Firmware Upgrade without need of the computer.
Then by following the straightforward included instructions,you can set your 2B into bootloader mode and then connect it to your computer.
Before you connect the FC in bootloader mode(boot button pressed while connecting the USB) to your PC, please install this driver.
RevPi Gate modules have control lines on thePiBridge that can be used to set them into bootloader mode to perform firmware updates via the PiBridge.
A change from bootloader mode to firmware mode will only take place if the entry function, device identifier und crc are present and correct.
If still no serial portshows up ensure that your Brick is in bootloader mode and that it is correctly recognized by your operating system.
If a RevPi Gate is now connected to the power supply and the PiBridge is connected to a RevPi Core that is not yet connected to the power supply,the RevPi Gate switches to this bootloader mode.
Master Brick hardware version 2.0has a change in its PCB layout that interferes with bootloader mode if a Master Extension such as RS485, WIFI(2.0) or Ethernet is present in the stack.
On Windows you might need to install the Atmel driver atm6124_cdc.inf from the drivers subfolder in the Brick Viewer installationfolder to make Windows detect a Brick in bootloader mode correctly.
Download OnePlus 3/ 3T B fast mode downloading or by long pressing the power button,and then select the bootloader mode, or by pressing the button volume up+ button Power after turning off the device.