Examples of using Ferrite core in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Ferrite cores for easy PCB assembly.
Pass the fastener through the ferrite core.
Attach a ferrite core in the same way that one is attached to a serial cable.
Pass fastener through ferrite core.
If a ferrite core is not included, perform steps(1) and(5) only.
Molded molex connector with ferrite core China Manufacturer.
They are typically constructed using a coil and a ferrite core.
The ferrite core is normally packed so it is opened, as shown in Fig. 3-2.
The following describes how to install the ferrite core and make the actual connection.
Ferrite Core for Power Cord: The ferrite cores are used to shield the cables from interference.
B Maximum distance between the ferrite core and the other end of the cord inserted in the AC outlet.
Ferrite cores are subject to various loads during assembly and other applications.
For that reason we offer you a special USB cable with ferrite core and gold-plated circuit points for an optimal signal quality.
Ferrite Core for Power Cord: The ferrite cores are used to shield the cables from interference.
When using network connections,pass the CAT5 cable seven times through a ferrite core(Figure 2.4), available from Crown Audio Inc.
Note:Whether there are a ferrite core and font setting card depends on the reader/writer model.
Connect the AX44 to DS2416 connector“IO-A()” using thesupplied 20-pin cable connect the end with the ferrite core to the DS2416.
How to use the ferrite core(Depending on model)- Use the ferrite core to reduce the electromagnetic interference in.
Connections: miniHDMI(type C, 19-pin) male to DVI-D(Dual Link- 24+1) male Supports resolutions up to 1920 x 1200 at 60 Hz Data transfer rates up to 5.1Gb/s DVI-D connector with screws With 1x ferrite core Gold-plated contacts Cable diameter: approx.
We are machining ferrite cores according to your requirements or design and manufacture totally new shapes and sizes.
AC power cord(1) AC plug holder(1) Remote Commander RM-921(1) Size AA(R6) batteries(2) Ferrite core(2) Foot support bracket(2) Screws for foot support bracket(6) Monitor stabilizer(2) Operating instructions 1.
If a ferrite core is not open, use a screw driver to pry it apart, taking care not to damage the core or lock.
Build this transformer with a ferrite core with double"U" and two separate windings, one on one leg and one on& 8217; other.
If a ferrite core is included, install the ferrite core onto the Ethernet cable according to the following procedure to prevent electrical noise.
When connecting a cable, open the ferrite core and clip it around the cable near the plug as shown in the figure.
The ferrite cores are used to shield the cables from interference. When connecting a cable,open the ferrite core and clip it around the cable near the plug.
Overmolded Cable For Mole cisco The RF wire withgold plated terminal also molded ferrite core by sequence on wires We specialize in this kind of cable assembly overmolding Our customized molded cable are built precisely following customers spec….
Ferrite Core for Power Cord: The ferrite cores are used to shield the cables from interference. When connecting a cable, open the ferrite core and clip it around the cable near the plug as shown in the figure.
A special process encapsulates the ceramic disc, ferrite core, coil and electronics with the connecting cable inside a gas-tight stainless steel housing.
Molded molex connector with ferrite core The molded molex 2 54pitch connector by right angle type for conversion Also molded together with ferrite core for Interference avoidance The molded design as below engineer drawing To avoid molding filling….