Examples of using Half duplex in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Full and half duplex operation 1.
Data transfer channels TxD and RxD, full/half duplex.
Private calls; half duplex, with or without ACK.
Half duplex transmission, single-mode fibre 9/125 µm.
Offers full support for half duplex and full duplex RS-485 communications.
Half duplex operation and repeater hubs do not exist in 10GbE.
The default is: 115200 baud, parity none, 1 stop bit,word length 8, half duplex.
Half duplex on one floor plus basement with a plot of 1,000 sqm….
IEEE 802.3x flow control for full duplex operation andback pressure for half duplex operation.
Supports full and half duplex for 10/100Mbps, and full duplex for 1000Mbps.
Serial interface: switchable inside the pyrometer: RS232 or RS485 addressable, half duplex; baud rate up to 115 kBd.
RS422/RS485 Mode, Echo on/off, full/half duplex, termination resistors of RxD and TxD independently activable.
EIA-422 point to point connections including hand-shake,EIA-485 2-wire half duplex and 4-wire full duplex systems.
As DNP 3.0 is also used for half duplex party-line operation, a mechanism to prevent collisions was added.
Adaptability: Â Supports two RS-485 modes: Full Duplex and Half Duplex with TxD echo cancellation.
Since the RS-485 support two wire half duplex, which means the RS-485 only have two lines to receive data and send data.
NB: To see what you input, either switch your modem to half duplex or put your local echo'on.
Half duplex means sound can flow in both directions, though only one stream of sound can be active at a time.
Flow control for full duplex and backpressure for half duplex avoids frame dropping as port blocked.
Choose item allows you to set up the Network Speed, 10 or 100M, and Transmission Mode,Full or Half Duplex, and so on.
Data transmission to weighing terminal:9600 baud/ 8 Bit/ No Parity/ Half Duplex connecting cable to weighing terminal not included.
Since it is not possible for multiple transmitters to drive the line simultaneously,each channel must be switched on when required half duplex.
Digital interface to the pyrometer Can be changed between RS232 or RS485 half duplex, for communication with the measurement pyrometer.
Transceiver, half duplex, sending and receiving data conversionautomatically, as long as the interface to send/ receive data to the conversion time is short;
Change your Ethernet switch configuration to a setting other than half duplex when you select Auto negotiate speed and duplex settings.
At this stage communication is possible in Half duplex(communication is bidirectional not simultaneous) with other users that have the same system and/or have set their transceiver on the same channel as yours.
This enables the wireless interface to provide a fullduplex mode in addition to simplex, half duplex and permanent broadcasting, thus permitting simultaneous bidirectional transmission.
This parameter ist only used for the connection type"half duplex" and is determined by the initial transient behaviour of the used transmission equipment.
The Gigabit Ethernet Switchsupports flow control when operating in half duplex mode, and supports IEEE 802.3ab in full duplex mode, ensuring that your data transfer and network connectivity continue to run smoothly and uninterrupted.
