Examples of using Lath in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Lath and plastet re stucco and remodeling.
The last few pieces of lath get installed.
Lath cut and not cut(various sections);
Nails or wire ties to secure the rib lath.
Lath and plastet re stucco and remodeling More information.
Oh, we have already said lath and coffered ceiling.
The lath installation continues with everyone involved.
At the edge also attach to a lath a clip for a cord.
Wooden lath for fastening of a curtain over a window.
To disassemble the rafters and lath used axes, saws and a crowbar.
Rib Lath should be lapped at the sides wire tied at intervals not exceeding 150mm.
At the ends of the sheets, the Rib Lath should be overlapped with at least 100mm 4”.
Drywall construction became prevalent as a speedier alternative to traditional lath and plaster.
In addition, the lath ceiling is durable, and caring for it is simple.
The crest acts from an edge of an obverse plate on 5MM, its thickness- 4MM,the groove is deepened in a lath on 5MM.
Sheets stacked on lath by partial mutual overlapping width of about 20 cm;
The folding table representing a board is convenient For kids,attached on loops to the narrow wooden lath horizontally beaten to a wall in using.
These walls are plaster and lath, completely invisible to the radio spectrum.
Rib Lath must be fixed with the apexes of the ribs in contact with the support or the backing.
Printing machine with automatic lath feeding system and four offset system coating heads.
Lath(Holland) Thanks to Marilena I learned not only how to speak like an Italian, but“act” like an Italian.
Visually increase the height of the bathroom can be by installing a lath ceiling light colors, or by assembling a mirror design.
After that a lath in horizontal position by a crest downwards temporarily fix on a table or to a floor.
If under the lagged behind lath there was a lot of mastic, it can be fused any nagretym a metal subject.
Hollow Tile, Lath, Wall Board or Metal 1/4”(M6) screw Type or Wing Type toggle Bolts Dependent on wall thickness.
Blue macaws(Psittacus hyacinthinus, Lath), which live in the dense tops of these palms, flew up screeching above us.
Fasten a lath screws, as is shown in drawing; track that the hanging edge of a lath has been turned in a doorway.
For this purpose at a lath are provided 2-3 shkanta, and In the bottom edge of a frame there are corresponding apertures.
The bottom lath is fed from the machine infeed and the top lath is fed from a ramp that guides it until it is placed upon the bottom lath.
Then another layer of lath is installed to maintain an air gap on both sides of foil insulation and then the final layer of timber boards are installed.
