Examples of using Length should in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
The length should be divisible by 25 mm.
Therefore, the cable length should not exceed 6 m.
Its length should be at least 70 cm.
Extension cords over 5 metres in length should not be used.
Hose length should not exceed 1.50 metre.
Wall-paper cuts on the panels which length should be slightly more necessary.
Its length should be shorter than 1 cm width blinds.
Having somewhat wider rear teat placement, teat length should be kept in mind.
The text length should not exceed 300 words.
When using HITACHI alloy head(CH-100), initial cutting line length should be about 17cm each. Fig. 1-11.
Its length should exceed the average at least 1.5 times.
Jumper height reaches 6-9 rows of masonry, and the length should be half a meter more than the width of the opening.
Length should be equal to the perimeter of the basket plus an allowance of 5-10 cm.
Such branches length should be 30-40 cm.
The length should be twice the longest edge length skirts plus eaves for lambrequin.
In this case, its length should be at least 35 cm.
Its length should be such that the boundary between the gate and the counter there is a gap in the two centimeters.
Remember the audio length shouldn't exceed 40 seconds.
The length should be 2 to 3 DIN A4 pages, so that the program committee can obtain a comprehensive overview of the contents of the presentation.
Leggings can be worn under anything, but their length should not coincide with length of a skirt or dress.
Br> Electrical insulating shoes outsole wear scar length should not exceed 10MM; wear loss of electrical insulating oil on canvas shoe is not greater than 1.4cm3;15kV and electrical insulating rubber boots wear loss not greater than 1.0cm3;20kv and above wear loss of electrical insulating rubber boots is not greater than 1.9cm3.
When using HITACHI alloy head(CH-100), initial cutting line length should be about 17cm each. Fig. 18.
The power cable length should not exceed 2 metres.
The only obligatory requirement-nails have to look accurate and well-groomed, and their length should not come more than to 5 mm for small pillows of fingers.
If the roller upper feed is not needed for a long time, then the feed length should be adjusted to the minimum value with the help of the setting wheel, in order not to unnecessarily load the mechanics.
Approximate lengths should be 9in(230mm) for the blue and white wires, and 0.75in(19mm) for the internal shield.
