Examples of using Load changes in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
This also provides excellent dynamic response with load changes.
Load changes are detected in milliseconds. The output is adjusted using automatic power derating.
Advanced equipment design optimised specifically for frequent, fast load changes.
Sudden load changes due to short circuits in the network can lead to high mechanical forces that stress the drive train.
A response time of under 20 µs makes the filter especially suitable for rapid andsubstantial load changes.
The Emotron technique reacts quickly to peak loads, abrupt load changes or inaccurately set ramp times.
In electronic systems,joints are particularly vulnerable to the effects of impacts or load changes.
Frequent, strong load changes by short throttle bursts and jerky lowering of the revs also reduce the life of the clutch linings.
For example, well designed,lightweight handlebars may withstand more load changes than heavier models.
Drifts, load changes and free driving- partly with timekeeping- on various handling routes characterize this driver-demanding training program.
In a test at the Material Testing Facility and Hanover the spiral cables withstood over one million load changes without fail.
Building technology: stresses resulting from rapid, frequent load changes and/or effects of climate change; debris diversion tunnels;
Even in the lowest measuring range of 100 mbar,it is extremely overload resistant and is capable of millions of load changes.
Additionally, high-speed roll doors are usually larger, manage greater load changes and have advanced safety features.
The intelligent self-learning motor models of the servo-systemare in a position to automatically compensate vibration and load changes.
A major drawback of the Qi standardis the interference-prone data transfer in rapid load changes, due to its impedance modulation specification.
The used silicon sensor is built into a sturdy stainless steel case, extremely resistant to overloads,and capable of handling millions of load changes.
No defects were discernible even afterperforming several load tests in the form of rapid load changes between 30 and 120 l/m2h over two hours each.
They provide a reliable system for clamping and machining even under extremely difficultconditions with pulling cuts or cuts with frequent and abrupt load changes.
These devices use a measurement method that isadapted to the frequent and fast load changes in passenger cars or commercial vehicles, thus avoiding false tripping.
Since today mainly on a bmx bike, the small sprocket and chain rings are gone,this course is to particularly strong and load changes are not uncommon.
Dynamic systems come to the rescue whenever rapid load changes cause dynamic influences on the voltage at the connection point, or whenever a highly sensitive voltage control is required.
A further advantage over the steel band is the shock reserve which is hard braking needed at load changes such as a truck.
Μs and minimal overshoot, even during demanding load changes, the power supplies of the NGL200 series are ideally suited for the supply of IoT and other battery-powered devices.
The center of gravity of this extreme Cayman is in the middle of the car-facilitating rapid load changes and even faster lap times.
Thus parasitic currentoscillations of a few 100 A amplitude can arise during load changes, which is why fine tuning of all components in the overall system can lead to considerable efficiency improvements.
Its high switching frequency andcurrentmode control enable a very fast transient response to line and load changes without sacrificing stability.
These include a tendency to tachycardia, expressed respiratory arrhythmia, presence of supraventricular arrhythmias,paroxysmal tachycardia and inadequate load changes in cardiac output.
Aside from reliability during long-term operation, the power plant andaircraft turbines must show sufficient resistance against short-term load changes and start-stop processes.