Examples of using
Minimum impedance
in English and their translations into German
{-}
Colloquial
Official
Ecclesiastic
Medicine
Financial
Ecclesiastic
Political
Computer
Programming
Official/political
Political
Observe the minimum impedance of 4 ohms!
Beachten Sie die minimale Impedanz von 4Ω!
Mm jack for connecting headphones minimum impedance 8Ω.
Mm-Klinkenbuchse zum Anschluss eines Kopfhörers(Impedanz min. 8Ω) 8.
Connect the headphones(minimum impedance 8 Ω) to the 6.3 mm jack PHONES 14.
Den Kopfhörer(Mindest impedanz 8 Ω) an die 6,3-mm-Klinken buch se PHONES(14) anschließen.
Spring terminals for connecting a speaker(minimum impedance 4 Ω) 7.
Federklemmen zum Anschluss eines Lautsprechers(Impedanz min. Ω) 7.
Connect the headphones(minimum impedance: 8 Ω) or the control monitor system to the jack PHONES/ CTRL-ROOM 51.
Den Kopfhörer(Mindestimpedanz 8 Ω) oder die Regie-Monitoranalage an die Buchse PHONES/ CTRL-ROOM(51) anschließen.
Connect an auxiliary cabinet with a minimum impedance of 2 ohms here.
Zusatzbox mit einer Mindestimpedanz von 2 Ohm.
The minimum impedance of all connected speakers must not go below 4 ohms i.e., don't plug in two 4-ohm cabinets!
Die minimale Impedanz aller angeschlossenen Lautsprecher darf nicht unter 4 Ohm liegen d.h. verbinden Sie nicht zwei 4-Ohm Lautsprecher!
MONO OPERATION minimum impedance of 2 ohms.
MONO-BETRIEB Minimalimpedanz von 2 Ohm.
Mm jack for connecting stereo headphones minimum impedance 8 Ω.
Mm-Klinkenbuchse zum Anschluss eines Stereo-Kopfhörers Impedanz min. 8 Ω.
Connect headphones(minimum impedance 8Ω) to the jack 11.
Einen Kopfhörer(Impedanz min. 8Ω) an die Buchse(11) anschließen.
Output SPEAKER:6.3 mm jack for a passive speaker system minimum impedance 8 Ω.
Ausgang SPEAKER: 6,3-mm-Klinkenbuchse für ein passives Lautsprechersystem Impedanz min. 8 Ω.
Connect the headphones(minimum impedance 8 Ω) to the jack 19.
Den Kopfhörer(Impedanz min. Ω) an die Buch se(19) an schlie-ßen.
Output PHONES(6.3 mm jack) for connecting stereo headphones(minimum impedance 32 Ω) 7.
Ausgang PHONES(6,3-mm-Klin ke) zum An schluss eines Stereo-Kopfhörers(Mindestimpedanz 32 Ω) 7.
For this purpose connect headphones(minimum impedance 2 x 8Ω) to the 6.3 mm jack PHONES 16.
Dazu einen Kopfhörer(Impedanz minimal 2 x 8Ω) an die 6,3-mm-Klinkenbuchse PHONES(16) anschließen.
These two outputs(sink/source type)are intended to switch logic inputs or outputs with a minimum impedance of 10 kΩ e. g.
Diese beiden Ausgänge(Sink/Source-Typ) sind zum Schalten von Logikeingängen oder -ausgängen mit einer minimalen Impedanz von 10 kΩ z.
Speakon jacks for connecting the speakers(minimum impedance 4Ω); configuration see chapter 5.9 2 Safety Notes.
Speakon -Buchsen zum Anschluss der Lautsprecher(Impedanz min. 4Ω); Buchsenbelegung siehe Kap. 5.9 2 Hinweise für den sicheren Gebrauch.
Output PHONES(6.3 mm jack) to connect stereo headphones(minimum impedance 8 Ω) 15.
Ausgang PHONES(6,3-mm-Klinkenbuchse) für den An schluss eines Stereo-Kopfhörers(Impedanz mindestens 8 Ω) 15.
The minimum impedance of 4 Ohm lies at 200 Hz. The waterfall spectrum is impeccable as well as step response and acoustic phase.
Bei 200 Hz liegt das Impedanzminimum von 4 Ohm, makellos sind die Diagramme des Wasserfalls, der Sprungantwort und der akustischen Phase.
BRIDGED OPERATION(MONO) minimum impedance of 4 ohms.
BRÜCKENBETRIEB(MONO) Mindestimpedanz von 4 Ohm.
When mixing, both the master signal and the PFL signal of each input channelcan be monitored via stereo headphones minimum impedance 32 Ω.
Beim Abmischen kann sowohl das Mastersignal alsauch das PFL-Signal jedes Eingangskanals über einen Stereo-Kopfhörer(Impedanz min. Ω) abge.
BRIDGED OPERATION(MONO) minimum impedance of 4 ohms.
BRÜCKENBETRIEB(MONO) Minimalimpedanz von 4 Ohm.
The power amplifier is designed for loudspeakers with a minimum impedance of 4 Ohm.
Die Endstufe ist zur Ansteuerung von Lautsprecherboxen mit einer Mindestimpedanz von 4 Ohm ausgelegt.
It is possible to connect an additional speaker with a minimum impedance of 8 Ω to the 6.3 mm jack STANDARD SPEAKERS(9) in parallel to the internal speaker.
An die 6,3-mm-Klinkenbuchse STANDARD SPEAKERS(9) kann parallel zum internen Lautsprecher ein Zusatzlautsprecher mit einer Mindestimpedanz von 8 Ω angeschlossen werden.
The power amplifier is designed to control speakers with a minimum impedance of 4 Ohm per channel. The device must only be controlled by a low-level audio source.
Die Endstufe ist zur Ansteuerung von Lautsprecherboxen mit einer Mindestimpedanz von 4 Ohm pro Kanal ausgelegt. Das Gerät selbst darf nur mit einer niederpegeligen Audioquelle angesteuert werden.
Terminals SPEAKER for the speaker systems(minimum impedance 4 Ω) 26.
Anschlussklemmen SPEAKER für die Lautsprecherboxen(Impedanz min. Ω) 26.
Mm jacks SPEAKER OUTPUT for connecting the speaker systems(minimum impedance 4Ω) for the right and left channels.
Mm-Klinkenbuchsen SPEAKER OUTPUT zum Anschluss der Lautsprecherboxen(Impedanz min. 4Ω) für den rechten und linken Kanal 29.
Most power amplifiersare capable of safely driving speakers with minimum impedance of 8 ohms or 4 ohms.
Die meisten Verstärker können Lautsprecher mit einer Mindest-Impedanz von 8 Ohm oder 4 Ohm gefahrlos versorgen.
When connecting three headphones to each channel, the minimum impedance of each headphone.
Wenn Sie drei Kopfhörer an jeden Kanal anschließen, sollte die minimale Impedanz jedes Kopfhörers.
RF antenna is designed specifically for LIGHTSPEED for absolute minimum impedance and maximum signal strength.
Die Funkantenne wurde speziell für LIGHTSPEED für minimale Impedanz und maximale Signalstärke entwickelt.
Results: 53,
Time: 0.0548
How to use "minimum impedance" in an English sentence
Maximum output power 2 X 15 watt with minimum impedance 4 ohm .
Ok, this one is a little better - minimum impedance of 3.5 ohms.
The specified sensitivity is 84dB/2.83V/m, the minimum impedance 4 ohms at about 150Hz.
Rockville Speaker Cables are engineered for maximum signal transfer with minimum impedance loss.
System sensitivity is around 87 dB/2.8 volts and minimum impedance is 4 ohms.
Minimum impedance for this tweeter is 3.2Ω at 2.4kHz with a measured Re= 3.0Ω.
At the resonance frequency of 20MHz, the recommended minimum impedance measurement is about 6Ω.
In addition, the cylindrical container has a minimum impedance loads and hydrodynamic resistance (braking).
The minimum impedance that the WorkingPro 700 is designed to drive is 4 ohms.
The T2 is rated at 8 ohms, with a minimum impedance of 3.2 ohms.
Deutsch
Český
Dansk
Español
Français
Hrvatski
Italiano
Nederlands
Polski
Русский
Svenska
Turkce
عربى
Български
বাংলা
Ελληνικά
Suomi
עִברִית
हिंदी
Magyar
Bahasa indonesia
日本語
Қазақ
한국어
മലയാളം
मराठी
Bahasa malay
Norsk
Português
Română
Slovenský
Slovenski
Српски
தமிழ்
తెలుగు
ไทย
Tagalog
Українська
اردو
Tiếng việt
中文