Examples of using Scsi controller in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Description Zero Channel SCSI controller.
Is your scsi controller compatible to the minolta scanner?
Description Single channel SCSI controller.
If not, the SCSI controller will complain later, that sharing is impossible.
The wds(4) driver supports the WD7000 SCSI controller.
The Adaptec 152* SCSI controller ISA boards.
ASPI provides an interface between software and the SCSI controller.
A powerful Ultra Wide SCSI controller is integrated on-board.
The 30 pin expansion slot can be used for DMA expansions, e.g. SCSI controllers.
Adaptec 1510 series ISA SCSI controllers not for bootable devices.
All SCSI controllers use the same set of/dev entries, so you do not need to create these.
Description Dual Channel SCSI controller with PCI-express x8.
SCSI controller connects to the parallel port, the port is passed through on the back of the drive.
Consider, for example, a SCSI controller and its overloaded bus.
The SCSI controller which is based on the Symbios 53C770 SCSI Sript Processor operates as a DMA busmaster device.
Access32 needs some rework, otherwise the SCSI controller does not work.
Adaptec 174x series EISA SCSI controller in standard and enhanced mode aha(4) and ahb(4) driver.
Check the connection of the SCSI cable on the CYBERSTORM MKIII SCSI controller and on the SCSI unit.
Such configurations include some SCSI controllers, most SATA disks, and external drives operating on USB or Firewire.
The indicivdual SCSI devices are then beeingconnected to the cable directly between these terminated ends, and the SCSI controller itself also acts as a SCSI device please also see Figure 7.
Disconnect the Ultra/Wide SCSI cable from the SCSI controller and from all other attached devices, and then remove the Ultra/Wide SCSI cable from the system.
If you install the Windows Small Business Server 2008 operating system on Small Computer System Interface(SCSI)disks connected to a SCSI controller and pre-configured with RAID 1, the following error message is displayed.
Ini file, copy the correct device driver for the SCSI controller that is used on the computer to the root of the boot disk, and then rename the device driver to Ntbootdd. sys.
According to information from thedrivers themselves, they also support a number of additional SCSI controllers, partly designed as onboard chipset(AIC), partly as adapters AHA, ASC.
Additional SCSI controllers are required for libraries with five or six tape drives to ensure that no SCSI bus becomes a barrier to maximizing throughput.
To run multiple concurrent jobs with more than 15 disks,you need to add more SCSI controllers to your Veeam Proxy server that is responsible for hot adding the disks.
The SCSI controller is only needed for vShield Endpoint version 1.0, ensure the guest virtual machine has a SCSI controller installed for vShield Endpoint 1.0.
This disk will need to be attached to a SCSI controller which is supported by the SRM firmware or an IDE disk assuming the SRM in your machine supports booting from IDE disks.
The SCSI Controller of the CYBERSTORM MKIII can only be used in the Amiga 3000 Desktop after a modification of the A3000 mainboard, as the CPU slot of the A3000 is missing an important signal(INT2) which is necessary for the operation of the SCSI controller. .
If the SCSI controller is a separate card, this would be a relatively straightforward process, but if the SCSI controller is part of the system's motherboard, it becomes much more difficult to justify the economics of such a change.