Examples of using Set pressure in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Full opening at set pressure.
The set pressure can be drawn from the quick lock.
Safety valve set pressure: bar± 5.
Above 1 bar set pressure 5% up to the max. valve lift;
P opens to PT as soon as the set pressure is exceeded.
Above 1 bar set pressure 10% up to required valve lift;
During the final phase, the boiler is heated up until the set pressure is reached.
Set pressure from 0,005 bar up to 2 bar see sheet DM512/2.1….
Invia Liberty builds up the set pressure and keeps it constant.
The set pressure can be drawn from the quick-lock coupling 5.
The motor will stop automatically when the set pressure and the developed force.
As soon as the set pressure is reached, it is automatically switched off.
This is influenced by the size of the wound, the leakage and the set pressure.
Pay attention: the set pressure with LP steam is formally 0.5 bar!
Failure to reach the set pressure within 30 seconds of continuous operation of the machine.
The outlet pressure change(offset) from the“set pressure” which occurs as flow.
The set pressure is the same as the pressure of the entire system including the patient.
They reduce the load on the system by reducing pressure peaks if the set pressure is exceeded.
When the set pressure is exceeded, the safety valve opens and diverts a portion of the gases, vapours, or fluids and releases them into the atmosphere or into collection pipes.
Calculation of the distance between the maximum pressure in the system and the set pressure of the safety valve.
If the set pressure is not reached within a specific time, the power supply to the heating resistances is cut off and a warning message is shown on the display.
Südmo Single Seat Overflow Valves SVPSelect EAF+ are equipped with adjustable set pressure actuator.
Although this function does ensure that the set pressure will not be exceeded by more than 10%, the system will be heavily stressed by the non-proportional opening behaviour.
Finally, if the content of iron in the raw water is greater than 5 mg/ liter,before the filter-obezzhelezivateli or combination filter further set pressure aerator.
This is where you will select a RHPS regulatorseries, gas type, and pressure control range, and enter your inlet pressure, set pressure, outlet tube/piping ID, maximum line velocity, inlet temperature, molar mass, and specific heat.
To protect your system you should install a safety valve upstream of the overflow valve to prevent the maximum permittedoperating pressure(normally 1.5 x maximum set pressure) being exceeded.
Inside of machine head adopts photoelectric pressure switch, only if the two weldingneedle discharge welding pressure to achieve the set pressure, to protect the reliability of the welding, and double needle pressure can be adjusted.
If the pressure switch does not shut off the air compressor at its"cut-out" pressure setting, the safety valve will protect againsthigh pressure by“popping out” at its factory set pressure which is slightly higher than the pressure switch“cut-out” setting. .