Examples of using Time is displayed in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Press DISP-SET Time is displayed.
Time is displayed in hours: minutes: seconds.
The precise global time is displayed.
When time is displayed, both dots of the colons are switched on.
The symbol disappears and the time is displayed.
Time is displayed even when the system is off.
The disappears and the time is displayed.
Once the time is displayed and the hours flash, release the button again.
When time is displayed, press+/ST/SP to activate/ deactivate beep tone.
Push the button DSP(12) briefly until the time is displayed.
INZONE”- The time is displayed in which your pulse was during training within the set pulse range.
After manual setting of the time, the time is displayed.
A until thealarm time is displayed.- Hold down the“MODE” button(5) for about three seconds until the sound signalis issued.
Switch the device to the standby mode with the POWER button the time is displayed.
Briefly press the button“SET”(14); the time is displayed in the figure on top, this is 23.
When the battery is installed and the unit is OFF, the time is displayed.
When the time is displayed in the lower display line, push the button“12/24”(2) briefly to switch between 12h- and 24h-mode.
Keep the button PTY/CLK(11) pushed until the time is displayed and the hours flash.
Switching the Device on/off(12/35) Switch the device to the standby mode with theSTANDBY/ AL. OFF() button the time is displayed.
After proper recognition of the DCF signal and evaluation, the time is displayed in the lower area of the display. .
The programming takes effect 5 seconds after setting, the two LED's on the left(cooking time and end time) light up and the time is displayed.
The microwave automatically switches over to standby mode, and the time is displayed, if no button is pressed for a longer period.
Once a valid signal was received,the DCF symbol stays permanently visible and the time is displayed.
Press SLEEP repeatedly within 5 seconds until the desired sleeper time is displayed. y SLEEP and either 120, 60, 30,10 or OFF are shown.
During a call,the called or calling phone number and the elapsed call time is displayed.
The microwave oven automatically switches to standby mode and the time is displayed if no button is pressed for a long time. .
Set the second function with the FUNCTION button(2)(fig. 1) and confirm with the START button(5)(fig. 5). Theoven emits a short beep and local time is displayed again.