Examples of using Total pressure in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
It's going to be 20% of the total pressure.
Low pressure gas: the total pressure is lower than 0.4 MPa 65 psia.
Pitot tube for measuring the total pressure.
For the total pressure to be measured in addition, another sensor needed to be installed.
Hoeeqdzo8"Hydraulic press for panel parquet Total pressure kg.
So if we want to figure out the total pressure first, we can just apply this 100 moles.
Transient simulation of sunroof buffeting of an SAE body total pressure.
Description The Pitot tube enables the total pressure in a fluid flow to be measured.
The sum of the static and dynamic pressures gives the total pressure.
And so the total pressure should be equal to the pressure of each of the partial pressures of each of the gases.
Air flows from 0- 7.650m³/h and total pressure up to 1.750Pa.
The simple Pressure Probe(pitot tube or tailpipe) measures only the Total Pressure.
So the first thing to figuring the total pressure is, we have to figure out the total moles of molecules we have.
Due to this, the tension in the vessels decreases and the total pressure decreases.
But we need to figure out what is the total pressure in the container, or being exerted on the surface of the container?
The Pitotstatic tube has anopening opposite to the flow direction to measure the total pressure.
The TE line remains active, static pressure and total pressure are blocked by the insert.
Connect the total pressure connector to the syringe using the piece of tubing and slowly increase the pressure until the ASI reads~150 km/h approx.
Low pressure gas and oil multi phases media: the total pressure is lower than 1.83 MPa.
The total pressure can be calculated anywhere in a textile based ventilation system as the sum of the static and dynamic pressures. .
A process according to claim 5 wherein step B is performed at a total pressure between 2.6 and 2.9 MPa.
The total pressure upon one of the surfaces A{\displaystyle A} or B{\displaystyle B}- it is irrelevant as to whether it is imagined as black of reflecting- has the value.
Tetrafluoroethylene(TFE) was then fed to the reactor until the total pressure in the reactor reached 3.1 MPa.
Partial pressure is the amount ofpressure that a particular gas such as CO2 within a gas mixture(the atmosphere) contributes to the total pressure.
On one hand, they point directly against the flow and collect the total pressure, and on the other they point downstream and record the"sub-static" pressure. .
The total pressure is the pressure that needs to be produced by the fan to overcome the total resistance in the ventilation system, i.e. the loss from the individual types of resistance, such as filters, cooling/heating surfaces, elbows, frictional loss and the static pressure in the system etc.
Then the reactor was re-heated to 225°C, and tetrafluoroethylene(TFE)was again fed to the reactor until the total pressure in the reactor reached 2.76 MPa.
The impingement probehas an opening in the flow direction for measuring the total pressure and annularly at a well-calculated distance from the tip on the shaft lateral openings for the static pressure. .
The reactor was sealed and cool-evacuated, and then tetrafluoroethylene(TFE)was fed to the reactor until the total pressure in the reactor reached about 0.41 MPa.
CVD and plasma processes or the vacuum analysis of UHV systems, information about the total pressure is not sufficient, because in these processes detection and documentation of specific molecular species is required.
