Examples of using Wind sensor in English and their translations into German
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Ecclesiastic
-
Political
-
Computer
-
Programming
-
Official/political
-
Political
Mast cable for wind sensor B.
Wind sensor-added safety in windy conditions Included in electric version.
NMEA input for active NMEA 0183 wind sensor.
Sun and wind sensor Compact S.
Then press the button(39) that can be seen in the wind sensor battery compartment.
Sun and wind sensor Compact.
Particularly convenient andsafe is the electric version with remote control and wind sensor.
A wind sensor warns when the configurable wind speed is exceeded.
Use of the environment to avoid the flow of the wind, the wind sensor will also cause interference.
Ensure the wind sensor is pointing North to enable it be record accurate readings.
Manual winch drive, additional payment for electric drive with wind sensor and remote control.
The Aero hardwired light and wind sensor enables comfortable living both indoors and out.
In order to emphasise the high quality standards, Lufft operates its owncalibrating laboratory with a wind tunnel for testing wind sensors.
This wind sensor is an inexpensive transmitter for measuring horizontal wind speed.
For correct and accurate measuring, it is important to mount the wind sensor in such a way that its front side(marking E) points towards East-West.
If the wind sensor provides 1 pulse/second per km/h then the factor is 1 because: 1 pulse/s 1Hz 1km/h.
You can now perform afunction test by turning the wind wheel on the wind sensor and carefully moving the rain sensor to the left and the right you will hear a click.
The wind sensor evaluates the wind speed and converts it into an analogue 0-10 V output voltage.
If a dedicated Wind station is found(here ID 1) the wind sensor from this station is assumed to be the primary one, so it is mapped to"wind0.
If the wind sensor is connected to a digital input of multi Extension Air, the speed is transmitted every minute.
If more than one LSR 20 is connected to a wind sensor(optional) for each LSR 20 one WST 10.20 is required up to 5 pcs LSR 20 with one wind sensor.
If the wind sensor is connected to a digital input of the MultiExtension Air, the speed is transmitted per minute.
Ensure that the wind sensor is pointing North to enable it to record accurate readings.
The wind sensor is made from durable Lexan™/ABS and is strong enough to be permanently attached to the sensor assembly.
We offer a range of systems from simple wind sensors through to complex centralized climate control units which provide the exact level of luxury you desire for your shading system.
Wind Sensor The wind sensor collects both the wind speed and wind direction data at the point of mounting and sends this to the thermometer-hygrometer sensor for transmitting to the base station.
The rain sensor and the wind sensor are connected to the thermal hygro outdoorsensor with cables and the sensor then sends the data to the basis of the weather station via a 868 MHz signal.
The wind sensor measures wind speed and sends the data to thermo-hygro-sensor, which transmits the data to the base station.
This wind sensor is equipped with an electronically regulated heater which can also be disconnected to save energy if wished.
If you change from a Nexus wind sensor to the gWind sensor, you must move the mast cable from the wind port to the network port on the Nexus server on pins 5, 6, 7, and 8.