Examples of using Bit errors in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
PI: Probability that a frame arrives with no bit errors.
Small bit errors in a JPEG scan lead to image disruptions.
P2: Probability that a frame arrives with one or more undetected bit errors.
P2: Probability that a frame arrives with one or more undetected bit errors.
Hamming codes can detect up to two simultaneous bit errors, and correct single-bit errors; .
P2: Probability that a frame arrives with one or more undetected bit errors.
OFB mode has an advantage over CFB mode in that any bit errors that might occur during transmission are not propagated to affect the decryption of subsequent blocks.
Syndrome tables are a mathematical way of identifying these bit errors and then correcting them.
Upon receiving a data frame, the wireless NIC within the base station converts the analog radio wave or light signal into a digital signal and performs error detection to ensure that the resultingdata frame does not have any bit errors.
Telephone network modems, but not in LAN protocols such as Ethernet, since bit errors are so uncommon in short wires.
In electronics, cosmic rays andother sources of ionizing radiation causenoise pulses and single and multiple bit errors.
ECC memory uses a specialalgorithm not only to detect single bit errors, but actually correct them as well.
In the first case, the music publisher depends on the muchgreater tolerance that consumer players have for bit errors.
P3: Probability that a frame arrives with one or more detected bit errors butno undetected bit errors.
In the two examples above, Bob's calculated parity value matches the parity bit in its received value,indicating there are no single bit errors.
Hamming code is a set of error-correction code s that can be used to detect andcorrect bit errors that can occur when computer data is moved or stored.
The BER may be improved by choosing astrong signal strength(unless this causes cross-talk and more bit errors), by choosing a slow and robust modulation scheme or line coding scheme, and by applying channel coding schemes such as redundant forward error correction codes.
This network loop will eventually see its own timing"float away" from any external networks,causing mysterious bit errors and ultimately, in the worst cases, massive loss of traffic.
To detect d errors, you need a distance(d+1) code because with such a code there is no way that d-single bit errors can change a valid code word into another valid code word.
Fiber Bit Error Rates(BER) are typically 10E-13.
Bit Error Ratio BER.
This is usually reported as bit error ratio(BER).
Measuring the bit error ratio helps people choose the appropriate forward error correction codes.
Please allow a bit error due to manual measurement.
The most commonly encountered ratio is the bit error ratio(BER).
The bit error probability pe is the expectation value of the BER.
Improved SNR reduces the bit error rate.
The BER can be considered as an approximate estimate of the bit error probability.