Examples of using External load in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
An external load of 5,000 lb(2,268 kg) can be carried by the UH-1N.
It avoids powerfailure of the engine due to the suddenly increased external load.
Types of external loads will be devoted to the last chapter of this publication.
Capacity check testing range extension One external load added, the testing capacity range doubled.
External loads on a structure may be classified in several different ways.
A hardpoint, or weapon station,is any part of an airframe designed to carry an external load.
An external load is connected to the device to extract the electrons and harness power.
It carries a single gun in an undernose barbette, plus external loads carried on pylons beneath stub wings.
During external load testing in April 1999, Boeing used a V-22 to lift and transport the M777 howitzer.
The p-type layer and n-type layer are pressed closely against each other andlinked by a wire connected to an external load.
During external load testing in April 1999 Boeing used a V-22 to lift and transport the light-weight M777 Howitzer.
It also concluded thatcarrying a school bag was identified as an external load that may have an effect on the developing spine.
It is pretty much the same as the old one above, except forthe addition of the Volt meter and extra fuse blocks for the external loads.
In the armed variant, launch control radar, external load and fire control systems and various task systems will be added to the aircraft.
The single-engine, single-seat K-MAX is a low-maintenance aircraft that features a counter-rotating rotor system andis suitable for external load operations and designed specifically for vertical reference flight.
Series-parallel connection structure and external load retaining valve ensure that the actuating mechanism with higher load will not fall in operation.
Electrical contact layersare needed to carry the electric current out to an external load and back into the cell, thus completing an.
Retaining walls and abutment are force structure which assume all external load, the active earth pressure, the upper part of the structure of the dynamic load, temperature stress and so on, in a larger long term reinforcement under tension, as well as the effect of repeated dynamic loading, the molecular structure of materials fatigue, occurred in the performance of attenuation and speed up the aging grid.
The twin tail was essential to enable the plane to carry large, heavy external loads that would disturb the airflow around a conventional tail.
When lowering a heavy object slowly from an elbow flexed to an extended position, the muscles to flex theelbow joint perform eccentric exercise, since the external load(dumbbell) is greater than.
With the dual point hook systems,it can carry external loads at increased airspeeds due to the stability achieved with the dual point system.
When lowering a heavy object slowly from an elbow flexed to an extended position, the muscles to flex theelbow joint perform eccentric exercise, since the external load(dumbbell) is greater than the force generated by the muscle.
Both monocoque andsemi-monocoque are referred to as"stressed skin" structures as all ora portion of the external load(i.e. from wings and empennage, and from discrete masses such as the engine) is taken by the surface covering.
The twin tail was essential to enable the plane to carry large, heavy external loads that would disturb the aerodynamics of a conventional tail.
The twin tail was made necessary by the requirement to carry very large and heavy external loads, which would disturb the aerodynamics of a conventional tail.
Two additional electrical contact layersare needed to carry the electric current out to an external load and back into the cell, thus completing an electric circuit.
The load due toheat transfer through the envelope is called as external load, while all other loads are called as internal loads. .