Examples of using Maximum input in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Maximum Input Power.
Current for minimum, nominal, and maximum input.
Maximum input current.
Load current for minimum, nominal, and maximum input.
Maximum Input Power.
Backup switch over time: Maximum input: 6.6A.
The maximum input power.
It usually is described by the ratio of the maximum input power to the sensitivity.
Maximum Input Power(W).
However, please note the maximum input is 5V/2A as well.
Maximum input Power 120W.
Maximum input voltage 55V.
This is given as 60 mA, so a maximum input of 1.5 V+(60 mA)×(1k)= 61.5 V will stay within that spec.
Maximum input level +20 dBu.
Figure 1: Efficiency at nominal output voltage vs. load current for minimum,nominal, and maximum input voltage at 25°C.
The maximum input power: 11KVA.
For a clearer image switch to HDMI input, the black pear RC801 will display a maximum input of 1920*1080/60Hz.
DC maximum input current: 20A.
If they are present then thedevice has a switched mode input, and the maximum input voltage should be somewhat below the voltage printed on the capacitors.
Maximum input: 304ch inputs/ 8ch outputs.
This current level is called the drop-out current,and it is analogous to the maximum input voltage that a logic gate input will allow guaranteeing a“low” state(typically 0.8 Volts for TTL, 1.5 Volts for CMOS).
Maximum Input Voltage- Every piece of electronics has its limits when it comes to high voltage.
This current level is called the drop-out current,and it is analogous to the maximum input voltage that a logic gate input will allow to guarantee a"low" state(typically 0.8 Volts for TTL, 1.5 Volts for CMOS).
The maximum input pressure of 20.7Mpa(3000psi), corrosion, clean workshop assembly test, suitable for laboratory, high purity gas such as gas analysis.
Get the maximum input of correct English.
Maximum input pressure up to 20.7 Mpa(3000psi), corrosion protection, clean-room assembly test, suitable for laboratory, gas analysis and other high purity gas use.
Also noteworthy was that the maximum input power to the charging base was higher in the test where the phone was misaligned(11W) than it was in the well-aligned phone(9.5W).