Examples of using Reverse voltage in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
Uobr- reverse voltage.
So the LED is completely shielded from reverse voltage.
Reverse voltage VR 5 V.
Define reverse voltage.
Reverse voltage VR 5 V.
Diode D1 protects Q5 from reverse voltage spikes.
Reverse voltage VR 5 V.
(1)Measured at 1 MHz and applied reverse voltage of 4 V D. C.
Reverse Voltage(per dice) Vr 5 V.
NOTE1. Measured at 1.0 MHz and applied reverse voltage of 4.0V D. C.
Reverse Voltage(per dice) Vr 5 V.
Sometimes LED is very sensitive and can not withstand reverse voltage.
Reverse voltage consists of a voltage of the secondary winding and the voltage across the capacitor.
The width of the depletion region is proportional to the reverse voltage.
This is because, as the magnitude of the reverse voltage increases, the kinetic energy of the minority charge carriers also increase.
Base-Emitter is given forward voltage, while Base-Collector is given reverse voltage.
Light emitting diodesare not designed to be driven in reverse voltage and will not produce light under this condition.
Base-Emitter is given forward voltage, while Base-Collector is given reverse voltage.
D3 prevents reverse voltage on the gate while the 51W resistor limits the gate current to a safe value.
Choose a diode in which the value of rectified current and reverse voltage higher than estimated.
Reverse voltage strength of a diode is not as easily tested, because exceeding a normal diode's PIV usually results in destruction of the diode.
Avalanche diodes are designed to break down at a well-defined reverse voltage without being destroyed.
When a reverse voltage is applied a perfect diode does not conduct, but all real diodes leak a very tiny current of a few µA or less.
The depletion region stops growing when its potential difference is equal to the applied reverse voltage.
D3 prevents the reverse voltage of the gate while the 51 ohm resistor to limit the voltage flowing to the gate in order to safely drain voltage value.
When the coil is de-energized, the current was suddenly cut off,there is a high reverse voltage shock caused by the magnetic field change.
Diodes also have a maximum allowable reverse voltage, peak reverse voltage(PRV), or peak inverse voltage(PIV), above which a large current will flow in the wrong direction.
Again, it is important that diodes are matched to ensure that the reverse voltage divides equally(although a small resistor placed in parallel with each diode can be used to equalize the reverse voltages). .