Examples of using Reverse voltage in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Protection, VSWR protection, reverse voltage Protection.
PN Junction Plus reverse voltage, a few carriers difficult to inject, it does not emit light.
You can use any of the opposite potentialdifference of at least 400 volts for the reverse voltage.
Hence the time taken, t=(reverse voltage/ peak diode recovery).
The signal is controlled using theMTT4K contactless starter for a current of 80 A and a reverse voltage of up to 800 V.
PN junction plus reverse voltage, a small number of carriers is difficult to inject, so do not light.
Semiconductor diode VD, designed for direct current of about 0.2 A and reverse voltage not lower than 300 V.
PN junction plus reverse voltage, the minority carrier is difficult to inject, so it does not emit light.
Surge protection The ability of the LED to withstand surges is relatively poor,especially against reverse voltage capability.
Reverse voltage or ripple currents higher than specified can destroy the dielectric and thus the capacitor.
Double voltage mode The main and auxiliary electrodes connected to the reverse voltage can be doubled test voltage. .
In every case a reverse voltage lower than- 1.5 V at room temperature may cause the component to catastrophically fail due to a dielectric breakdown or overpressure, which causes the capacitor to burst, often in a spectacularly dramatic fashion.
Select the diodes from which the bridge is mounted,based on the magnitude of the current flowing through them and the magnitude of the permissible reverse voltage.
Therefore, aluminum electrolytic capacitors with non-solidelectrolyte can withstand a very small reverse voltage and, for example, can be measured with an AC voltage of about 0.5 V, as specified in relevant standards.
Therefore, when repairing, it is important to replace these diodes with the same high-frequency ones(the most common devices of type VS 60CPH03, STTH6003CW, FFH30US30DN),which should be designed for a reverse voltage of 300 V and a current of 30 A.
Voltage- Reverse Standoff(Typ).
However, the reverse-breakdown mode may be at a very low voltage, with a moderate reverse bias voltage causing immediate degradation and vastly accelerated failure.
LEDs driven directly from an AC supply of more than the reverse breakdown voltage may be protected by placing a diode(or another LED) in inverse parallel.
(3)Using 2DL-300 kV/ 500 mA high voltage rectifier silicon stack, The reverse withstand voltage is greater than 300kV, the average current is greater than 0.5a, the high-voltage rectifier silicon pile is installed next to the charging transformer, the charging voltage polarity can be automatically reversed by the transmission mechanism.
The strains reversed when the voltage was reversed.
Reversal is generally described as the percentage of the maximum rated voltage that reverses polarity.