Examples of using Frictional force in English and their translations into Japanese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
Enhance Frictional Force.
Frictional force is non-conservative force. .
F be the frictional force.
Note that I am using the maximum static frictional force.
Large frictional force makes easy polishing.
The'80s and'90s: facing frictional forces.
Hence, frictional force is non-conservative force. .
The energy needed to overcome the frictional force.
The second frictional force was closely related to the first.
Will Climbing Chalk increase the frictional force of rubber?
The frictional force of the contact surface between the material and the roll is large, and material transport with less slip is possible.
Can Tokyo Powder's chalk increase the frictional force of rubber?
Given that the frictional forces are typically in the 0.05- 0.1 N range, we recommend using a small 10- 50 N load cell for this application.
The tension must be applied to the hauling side in order tocause the frictional force.
Additionally, with a suction-force cancellation-type linear motor, frictional force reduction is reduced while thrust is increased.
However, in order to cause this frictional force, tension must be applied to the wire rope on the opposite side of the load. Please note this when purchasing this model.
Increased diameter disc5mm larger diameter disc over standard, with both frictional force and durability improved.
Finally, by integrating a microstructure for detection of frictional force into the probe, weve made it possible to install our probes into commercial atomic force microscope devices.
At the same time, the overcoat layer of silica gel feels good to touch,and the large frictional force can also be counted as a merit.
According to Coulomb's law of friction, frictional force is proportional to the normal load. In the micromachine environment, because of the reaction between surface forces, a large frictional force occurs that would be inconceivable in an ordinary scale environment.
As with disc brakes,wheel rotation is controlled by frictional force applied to the brake lining.
For conventional probes, it is not easy to precisely differentiate between friction and load, but our probe makes this possiblewhile at the same time simplifying the calibration of frictional force.
As the bearing washer pushes the hexagon nut, the frictional force between the hexagon nut and the bolt increases, preventing looseness.
Utilize repelling the strength and appeal of magnetic force too, make the train floating on the track can be accelerated or moderated forward,because there is no frictional force among car body and track.
This type of braking method involves the brake padbeing pressed onto the brake disc generating frictional force. Consequently, the faster the speed, the greater the heat produced by this rubbing, which in some cases leads to lower braking performance.
Also, it is necessary to be able to measure both static friction and succeeding dynamic slide friction. background The various kind of sensors were developed for pressure measurements,but there are very few which can measure the shear force frictional force.
The piston system accounts for 30% to 50% of mechanical loss in the engine; therefore,reducing frictional force between the piston skirt and the cylinder bore is a critical issue.
This decrease in frictional force is especially apparent where the catheter has been brought to elevated temperatures during a sterilization cycle, as the materials from which the handle and the control mechanisms are formed have a tendency to yield at elevated temperatures.
Insertion force is also a key value in characterizing needle geometry and sharpness, and in understanding the effects of velocity,viscosity and frictional force along the needle axis during insertion into soft tissues.
Many mechanisms have been developed to meet these requirements,and each of these mechanisms depends on frictional force to handle the media concerned. Tribology therefore plays an important role in improving performance in such areas as speed, precision, reliability, and so on.