Examples of using Multipath in English and their translations into Korean
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Programming
-
Computer
ECMP- All Active Multipath for Layer 3.
Etc/multipath. conf file as shown below.
RIP does not support multipath routing.
Flat Layer-2 MLAG 스파인- 모든 Active Multipath.
Resistance to multipath interference.
Simulate up to 56 channels for line-of-sight and multipath signals.
Active multipath using ECMP(up to 64-way).
ECMP stands for equal cost multipath routing.
On any given transmission, any one or more particular antennas at one or more SCS's 10 may receive signals that have been affected to varying degrees by multipath.
Including supported devices, can be found in the multipath. conf. defaults file.
Predicting the multipath delay is performed using well-known raytracing techniques or based on angle of arrival, or signal strength values, or by making estimated based on the physical model of the 3-D environment.
The GPS-Base uses Pulse-Aperture Correlator Technology to minimise the effects of multipath.
For more information about Multipath I/O, see Support for Multipath I/O(MPIO).
The GPS-700 Pin-Wheel Technology Antenna includes a ground-plane to minimise ground surface multipath and reflections.
Most routing algorithms use only one network path at a time, but multipath routing techniques enable the use of multiple alternative paths.
Addressed issue where installation of KB3121261 on a third-party, thinly provisioned Storage Area Network causes multipath I/O Event ID 48.
We have conducted test on air indoor and in strong multipath area with many wifi interferences and also a cellular repeater inside the buiding.
Furthermore, the SCS 10 and TLP 12 combined have been designed with additional means for removing multipath from the received transmissions.
For information regarding the setup and configuration of FCP or multipathing on Red Hat Enterprise Linux, see the Storage Administration Guide and DM Multipath Guide.
When the communications system incorporates MIMO technology, the complexity associated with the receiver unit can be significant,particularly when multipath is present.
This will cause problems for extreme northerly latitudes, affecting connectivity and causing multipath interference caused by signals reflecting off the ground and into the ground antenna.
However, when two antennas are closer than one wavelength,the two received signals have taken essentially the same path and experienced the same fading, multipath, and Doppler shift.
In one or more embodiments,the BWM state/mode may be equivalent to the L4 multipath management state/mode, for example, the L4 multipath management state/mode may indicate and/or initiate the use of MPTCP or similar protocols.
The reason for using data from multiple antennas at a cell site independently in the location processing is that the signal received at each antenna is uniquely affected by multipath, fading, and other disturbances.