Examples of using Test section in English and their translations into Portuguese
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
-
Official/political
The polycarbonate test section measures 41.8 by 22.5 by 8.9 cm.
It was designed by Dr. W. Frederick Gerhardt,and assembled by the staff of the Flight Test Section at McCook Field in Dayton, Ohio.
The test section comprised a 26-mm id, 9-m long transparent acrylic pipe.
Your score report gives you scores for each test section(0-30) and a total score 0-120.
The tunnel test section is square with an edge of 460 mm and a length of 1200 mm.
The transmission gamma of measures will be made by means of three test sections that have source and detector shielded.
A test section was built, comprising two valve diameters acrylic pipes of 34 and 70 mm.
In Europe, there are currently no hyperloop test sections, while a few exist in other parts of the world.
The test section was from the d. Lazaridi in-depth 7-8 measures, at one point today is covered by the olive grove.
The engine speed andvehicle speed on the test section shall be determined with an accuracy of 3% or better.
Held are global and local measurements of pressure loss andspeed to nine different flow conditions, over a test section.
This circuit has two test sections for the required heat transfer enhancing analysis.
The elements used were screens between the diffusers, one helmholtz resonator andone flap which were installed at the superior edge at the test section exit.
In this description, the test section, consisting of a rectangular channel with cross-sectional area of 6.0 x 6.5 mm² is detailed.
The characterization of such structures is aimed at the knowledge of the flow especially along the test section, which requires very specific conditions to analyze the fluid.
This work shows a contribution to the studies in the site of the flow in wind tunnel for low velocities through the use of passive attenuators at the test section.
Characterization of the flow profile in the test section of a recirculating water channel for hydrodynamic experiments at low Reynolds number, BP. IC.
In this context, this master¿s thesis presents an investigation of the blockage phenomenon in the submarine model darpa suboff placed in the test section of a cavitation tunnel.
The larger open loop wind tunnel has a Plexiglas test section measuring 60.9 x 40.6 x 8.2 cm, making it big enough to take two heat sinks side-by-side.
Although the"Help" function will be accessible at any time during the test, any time spent reviewing the"Help" screens will count against the allotted time for that particular test section.
For the experimental speed measurements analysis were performed at the inlet and outlet in the test section of the wind tunnel, using a pitot tube and a hot wire anemometer.
Our special CD's have simulated TOEFL test sections and practice sessions, so you will listen to and be exposed in advance to the same types of things you will receive on the actual test. .
Wind tunnel walls operating at this speed range are provided with engineering solutions to interfere minimally in the flow in the test section.
The current work brings an innovative methodology for determination of parameters of a test section for simulation of loss of coolant on supercritical water reactor in reduced scale.
The study presents a test section of 14 meters in length which features a porous medium and a pipe that allows transpiration in n points in order to get closer to the reality and incorporate the effects of transpiration.
An appropriate level of competence in the English language,through attaining a minimum of IELTS 6(minimum of 5.5 in any of the 4 test sections) or TOEFL 95 minimum of listening 21, speaking 23, writing 21 and reading 22.
There a test section was assembled to perform pressure and velocity measurements of the flow of water passing through a representative segment of a nuclear fuel element with 5x5 rods and four spacer grids distributed along it.
The tests were performed a boiling with a saturation temperature of 22 °c and saturation pressure of 302 kpa, with a mass velocity between 50 and 200 kg/(m²s)and heat fluxes in the test section between 7 and 40 kw/m².
The main goal of this work is to analyze the chffor labgene(nuclear-electrical generation laboratory) by an experimental design and test sections simulation in operating conditions by using cobraiiic/mit-1 code and the epri correlation for the chf.
In the case of experiments involving flow boiling, the tests were performed at a saturation temperature of 22°c with a mean saturation pressure of 323.5 kpa, with mass velocity ranging between 188 and 370 kg/(m²s)and constant heat flux in the test section between 28 and 134 kw/m².
