Examples of using The digital input in English and their translations into Russian
{-}
-
Official
-
Colloquial
Switches connected to the digital inputs.
The digital inputs are of type SchmittTrigger with.
Connect to the digital input using a suitable 75Ω screened cable.
Fire and security alarm systems are connected to the digital inputs of the MiniEM.
For example, use the digital input of an analog input signals.
With a spot of solder on bridge Trig/Adc,you get an oscillator that turns the digital inputs in Adc.
The digital input function can be disabled/enabled in the Initialisation files.
However, some controllers may be 6 IDC-10 connectors instead of IDC-50 to connect the digital inputs.
How the digital inputs are connected to X1A depends on the Smart Grid application.
In addition, you can enable email alerts when motion is detected orwhen the signal on the digital input.
Assignment of the digital input according to pin layout to zero reset all axes.
If the turntable has a“ground” wire,connect it to the screw terminal labeled“GND” to the left of the Digital inputs.
The digital inputs of Ethernet controllers are connected via“Pull Up” resistors to the controller power supply(3V3) voltage.
In case more than 1 digital input is closed(at the same time), the digital input priority is fixed: DI4 priority>…>DI1.
In addition, the digital inputs and outputs allow you to connect external devices such as IR sensors, switches and alarm relays.
Using a standard 75 ohm coax digital cable, connect the T14's coaxial output to the digital input connector on the outboard D/A converter.
After configuring the digital inputs, press“Save Settings” on the main form to load the application to the controller.
Using a standard 75 ohm coax/optical digital cable,connect the RC-1590's digital output to the digital input connector on the outboard D/A converter.
When using the digital input with a Multi Channel audio signal the processor DSP will decode the incoming audio stream including Dolby or DTS.
For the system to run in the"Recommended ON"operation mode(Smart Grid application), connect the digital input to the X1A/1+2 LAN adapter digital input. .
The digital inputs of NetModule based on ESP8266 is not a Schmitt-Trigger, so to avoid false counts you should add externally a Schmitt-Trigger.
Set analogue output voltage levels in each step, trigger systems using digital outputs, oractivate step transfers using the digital inputs.
The digital inputs are Schmitt Trigger, so the voltage must exceed 2 Volts, to take on"On" and must come down under 1 Volts, to take on"OFF.
Plint 1: Output”d1”(cooling 24V) Plint 4: Output”d2”(heating 24V) Plint 7: Input external sensor Plint 8: Input condensation sensor 2.2 Input functions Different types of sensors can be connected to the digital input 1 and 2.
Switches Switches(e.g. level switches)may be connected only to the digital inputs(IN1 to IN8) IN9- IN16, when circuit board cb-8in(1) present, IN17- IN24, when circuit board cb-8in(2) present.
DI1 weakest limitation(highest energy consumption)DI4 strongest limitation(lowest energy consumption) For the specification and the connection of the digital inputs, see the wiring diagram.
The digital input count has increased, and now includes two optical(24-bit/192kHz-capable) and two coaxial(24-bit/768kHz-capable) sockets, as well as a USB-B connection capable of decoding 768kHz PCM and DSD 512 files.
