Examples of using Total thickness in English and their translations into Russian
{-}
-
Official
-
Colloquial
Total thickness: 220um.
External walls will be three-layered with the total thickness of 430 mm.
Total thickness: 2,0 mm.
The tabletop is made from five ply blockboard with a total thickness of of 32 mm.
It has a total thickness of 410 um microns.
This wall is made up of separate sheets of steel and has a total thickness of about one meter.
The total thickness of the"Zodiac" panels- 16 mm.
The lower layer of the phantom did not contain PS, and total thickness of the phantom equaled 6 mm Figure 2.
Total thickness of the layer should amount to about 20 μm.
Development of coal seams with a total thickness of 18.5 m, six by overcutting and five by undercutting.
For the first tests we chose an external diameter of 30 mm and the total thickness is below the 5 mm.
The total thickness of anti-corrosion finish shall be 200 micron.
For pritachivaniya shoe soles, of textile materials and the total thickness of the skin layers of 8 mm.
In such a manner, total thickness of the wall composition turned out 200 mm.
Kronostep Silent laminated floor already contains the underlayer with total thickness of 0.3 mm, which perfectly dampens impact noise.
The total thickness of the three-layer structure does not exceed a few hundred nanometers.
The case of the composite safes, consisting of a steel walls anda special anti-breakout elements, the total thickness is 30 mm.
The total thickness of the Jurassic sediments in the Lower Sarysu trough is over 400m.
However, the critical dimension for most users is the amount of rubber over the first reinforcement layer, not total thickness.
Improved presentation of total thickness of a heating floor or wall on the build-up drawing.
While the high performance films produce ahigh amount of rigidity, the adhesive contributes its flexibility to the sound- with a total thickness of 22 µm to 60 µm.
Their relatively low total thickness means they can conform to slightly irregular surfaces.
In other tires where there is more separation between the individual ply cords,some sound energy will get through to the inside wall and measurement of total thickness will be possible.
Three layers of the new asphalt pavement with a total thickness of 19 cm were laid. About 44.000 tonnes of asphalt concrete mixes were used.
In some types of tires where there are many layers of ply cords and/or the ply cords are very close together,not enough sound energy will reach the inside wall to permit measurement of the total thickness.
This spirituality of a manual line,its size and total thickness determine the strength of its sounding, the tone and richness in overtones.
For one production cycle must be applied to three optical layers, one of these layers, which is located between two other layers- should be made of light sensitive material and its thickness must be within 0.002 mm,limiting it to two sides of the layers of optically transparent material should be each have a thickness of 0.005 mm, total thickness of this structure with three layers of- 0.012 mm;
In the case of an undersized weld,only a portion of the sound beam will reflect from the total thickness of the two metal sheets, while a portion reflects from a single thickness. .
The stratigraphic structure(total thickness of 380 m) can be defined by three main levels:(a) lower conglomerates(155 m);(b) productive stretch(40-60 m); and(c) upper sandstone-conglomerate level 154 m.
In the case of a single not reduced wall(example 1.) the factor 1.2 should be seen as an equivalent for the better absorption capacity of the double wall(example 2.), where the space between the two walls is able to absorb energy andin addition by means of a certain redundancy with the second wall a higher safety can be achieved even if the total thickness of the double wall is the same as the thickness of the single wall.
