Examples of using Flow rate in English and their translations into Serbian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
What's the flow rate?
Flow rate up to 2000 liters per hour.
Permissible air flow rate- 0.7 m/ s.
Flow rate will fill a gallon in about 2 to 3 minutes.
Select lower melt flow rate material.
Q- coolant flow rate per hour, measured in cubic meters;
The possibility of determining the flow rate of water.
Um, GPM is your flow rate, gallons per minute.
The image is translated into HEVC with 3840x2160 resolution, flow rate OK.
Deformity) 1、Melt flow rate is lower, and bad flowability.
We found an underwater volcano in this area with an unusually high flow rate.
In this case, the flow rate of the solution will be 100 l/ ha.
Sialometry: This is a simple procedure that measures the flow rate of saliva.
The flow rate of the working fluid is 100 ml per 10 kg of planting material.
The room temperature and the air flow rate should be moderate.
Low sampling flow rate, the minimum sampling flow rate 50ml/min.
Lower injection temperature andpressure 1、Select higher melt flow rate material.
Meanwhile, the flow rate of parking is increased by more than 30% before installation.
These physical processes include pressure,temperature, flow rate, and chemical consistency.
These sensors can measure the flow rate, the occupancy rate and velocity of traffic on a given portion.
Distributed fresh air system, with inverter measurement,the air pressure is constant and air flow rate is fixed.
The filter flow rate can be matched with the volume flow rate of the air compressor.
If it was manufactured in the'90s,it could have a flow rate of 5.5 gallons per minute.
Based on the flow rate and the size of the cabana, it would've taken about two hours for the propane to become deadly.
In the mode of intensive driving at high speed, the flow rate can increase to 11 liters per 100 km.
It can be used to convey various medium from tap water to industrial liquid at different temperature and with different flow rate and pressure.
Precise control of temperature,pressure, and flow rate is essential for successful, reproducible extractions.
The operation of pump shall refer to the performance region indicated by the thickened curve to prevent overheating due to too small flow rate oroverload of motor due to too large flow rate.
Low flow shower heads are the ones with a flow rate of less than 2.5 GPM at a water pressure of 80 pounds per square inch(psi).
When a pump operates too far to the right on the curve,the pump is delivering a flow rate greater than that for which it was designed.