Examples of using Voltmeter in English and their translations into Serbian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Latin
-
Cyrillic
Just set the Voltmeter to the DC scale, all right?
For troubleshooting, you must purchase a voltmeter.
How the voltmeter and ammeter are connected in a circuit?
How to connect the ammeter and voltmeter in the car?
The voltmeter, however, will register only 6.76 volts.
The illustration shows a typical schematic diagram connect ammeter and voltmeter.
How can ammeter and voltmeter are connected in a circuit?
The voltmeter is connected only in parallel to the power source, also subject to polarity.
Using a simple tester or a voltmeter, the voltage between the poles is measured.
In other words, what is the actual voltage at TP2 with the voltmeter connected as shown?
The voltmeter connects much easier, in any place where there is a"+".
Determining the voltage ranges for this voltmeter is simply an exercise in Ohm's Law.
Ideally, a voltmeter should have the greatest amount of input resistance possible.
To do this,you must be able to use a voltmeter, multimeter and oscilloscope.
What if this voltmeter suddenly stopped working when set in its middle range.
Si I was convinced only after we measured correctly with a voltmeter alternator load corect.
Repeat the DC voltmeter, AC voltmeter, and short-circuit tests described above.
So let's say if I take a measure of the voltage across those two terminals using what we call a voltmeter.
Correctly connect a voltmeter will help knowledge of its structure and principles of operation.
Analog instruments with moving coil and moving iron:amperemeter, voltmeter, and ohmmeter.
The voltmeter is connected in such a way that its powerful resistance does not change the measurement results.
The auditory signal is advised for large classrooms where voltmeter observance may be impossible.
The two electrodes are known as the anode and the cathode andboth are connected to a high resistant voltmeter.
Do not confuse a voltmeter with an ammeter, which is connected in series, because there should be a minimum resistance in it.
The potential is measured in volts, which is usually known as voltage, and the voltmeter is used to measure it.
The indication you get from a voltmeter, though, doesn't tell you anything about the quality of the signal, just its mere presence.
Full information on the operation of the generator andthe battery can be obtained by equipping the car with an ammeter and a voltmeter.
This is the reason that measurements with a voltmeter across an inductor are often reasonably independent of the placement of the test leads.
To remove equipment malfunction,you should have basic skills with tools such as an oscilloscope, voltmeter, multimeter and others.
Hypothesis: I Predict That the Metals That are good conductors will show a high voltage on the voltmeter and That the metals with low conduction portability will show a low voltage.