Examples of using Bottom surface in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Execution: Start with the bottom surface.
The bottom surface of the shelves should be equipped with reliable hooks.
The aquarium should stand on a stand all the bottom surface.
The bottom surface of the shelves should be equipped with reliable hooks.
Aphid larvae are usually hidden on the bottom surface of the leaf.
Especially for them, the bottom surface of the insoles is equipped with a protective gel completely transparent shade.
The general experience is a BGA device placed on a Bottom surface.
(5) The inclined surface and the bottom surface of the slider must be equipped with wear plates.
Pituitary gland- a small oval-shaped appendage on the bottom surface of the brain.
You can select fish which live on the bottom, surface, or between, or fish which are dynamic or calm, little or big.
Always hold the disc by the outer edges without touching the top or bottom surfaces.
CRF pitch angle" is the angle between the bottom surface of the fixture ISO/F2(B) as defined in Regulation No.
Mouse Pad Made of silicone, transparent, with integrated pad under the wrist,adhesive bottom surface.
Put some of that paste on an old toothbrush,and use it to scrub down the top and bottom surfaces of the rubber flaps along the neck of the disposal.
The non-slip rubberised bottom surface is designed for optimal stability, allowing you to use the MINIM on virtually any surface without worrying about the controller falling.
Hold the disc by the edges without touching the top or bottom surface with your fingers.
If the cage is arranged from a grid, the bottom surface needs to be covered with plastic, wooden boards or a rubber mat- rabbits easily develop painful knees.
Its height is adjusted so that the air temperature at the bottom surface is within 30 degrees.
To create a pond dug pit with a bottom surface and shores are removed stones and roots, then the pit is filled with sand, laying a protective layer of geotextile, and on top of it- the film.
These electrodes allow toperform welding work not only on the bottom surfaces, but also on vertical ones.
Double-sided reflow-welded boards(such as double-sided full SMD boards, mask-selectively welded double-sided panels) are usually the first to solder thenumber of components and the lesser type(Bottom surface).
The bonding surface of the flatdripper is a circular arc surface, and the bottom surface of the water outlet is a dome surface. .
On the transom, there are four groups of clops, for limiting the position of stringer, with short post welded on two ends for connecting raker,and three sockets on the bottom surface of two ends respectively.
Due to the use of a single panel, the in-line components are located on the top surface, and the surface-mount devices are located on the bottom surface, so the in-line devices can overlap the surface-mount devices during layout, but the pads must be avoided.
To Neoron act, the treatment of strawberry plants should be carried out very carefully,wetting and the bottom surface of the leaves.
One of these layers is an aluminumsheet which promises a perfect distribution of heat on the bottom surface and also the strength of the section.
The stopper is a screw with a"lamb" with a diameter of at least 10 mm,after installation it should fall on the bottom surface of the table top.
(2) In the event that solar panels are built on the bicycle path with the decision of application zoning plan except the bicycle routes of the type specified in the articles 5 th and6 of this Regulation, the bottom surface of the panels shall be at least 3 meters height from the road floor and the carriers shall be wind, snow and similar.
To cover the structure with polycarbonate, you first need to unfold it(material is sold in rolls),remove the protective film from the bottom surface and fix the canvas on the bottom of the screws.
