Examples of using Using a ruler in English and their translations into Slovak
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Now, without using a ruler, copy the shapes.
He cut the leg in four pieces, almost like using a ruler.
Using a ruler draw parallel lines every 2 cm.
All bending lines are drawn using a ruler and scissors.
Well if you think about it,it's really hard to measure out round columns using a ruler.
Using a ruler, draw a line down the exact middle lengthwise(2 inches in) on each.
Smooth rectangular pieces can be obtained without using a ruler and a pencil.
Using a ruler and gon divide the space into several zones, in the form of regular shapes.
Return the table to the traditional position,transfer the pencil sketch to it using a ruler.
Using a ruler and pencil mark up the inside of the countertop installation site bindings for the feet.
Measuring light is not as easy as using a ruler or scale, but there are instruments out there to help.
In the rooms the complex form(with columns, figuredwalls, pipes, and so on. p.) laid linoleum on the floor,mark the contours of the walls using a ruler and cut, taking into account the allowances.
On the output loop, using a ruler, draw 2 segments of the. One in length, from the longest finger to the heel.
Measure a section that was wrapped around your finger using a ruler in millimeters, divide this number by 15.7.
When using a ruler and pencil, draw a rectangle that will fit the size of the piece prepared for the closing.
To make holes in the center of the workpiece using a drill,you must first, using a ruler and a pencil, mark the center line and drill along it already.
In order to make it, using a ruler, a simple pencil and the handsaw itself, mark the place where the device will be located.
The first thing todo is to mark out the necessary templates using a ruler and a marker on a pre-prepared foam, after which the letters are cut with a sharp knife so that the edges are even.
Previously, to obtain results using a ruler or tape measure, now many builders actively using advanced opto-electronic devices, known as laser rangefinders.
Use a ruler to measure the length you marked for each foot.
Use a ruler to draw a triangular point on the front and back flaps, and then cut out with scissors.
Use a ruler to check that the pieces are placed at equal distance from each other and verify that all the pieces are parallel too.
Then use a ruler to measure five inches along the 22-inch sides of the frame, and make marks there for the second pair of legs.
Now Use a ruler to measure the heel-to-toe length you marked for each foot.
You can cheat and use a ruler, but most likely your hand will never learn to draw a perfectly straight, long lines.
We could use a ruler to measure length, and use a scale to measure weight.
Use a ruler, which is carried out by a knife incision Prototyping of two layers glued wallpaper.
When scanning Medium Format film, use a ruler to measure the distance from the start of one frame to the start of the next frame and then set'Input|.
Should I use a ruler?
You just need to use a ruler or protractor.